Abstract:The Institute of Plasma Physics, Chinese Academy of Sciences was contracted by General Atomics Company to develop a superconducting feeder system containing a pair of 50-kA high-temperature superconducting (HTS) current leads for ITER central solenoid magnet test. These HTS current leads (HTSCL) are based on the previous ITER lead design experiences. However, the vertical assembly design of HTSCL which is different from ITER's horizontal assembly causes the water leakage in the insulation flange during the initial phase. Some improvements were recognized and expected to avoid the potential risk for further prototypes and series production of ITER leads. Some development experiences are shared in this paper. The HTS current leads contain BiSCCO AgAu matrix tapes to minimize the heat load to 4.5 K end. Its resistive part is cooled by 50-K helium. In the HTS part, the conduction cooling is adopted. The HTS current leads were integrated in the feeder system to perform 4.5-K full current test. The factory acceptance test was implemented to verify the high-voltage and thermodynamic performances. The maximum current of 55 kA was achieved. The test indicates that the helium mass flow consumption is 3.3 g/s per lead and the loss of flow accident time is approximate to 10 min at the nominal current with the stoppage of 50-K helium. The insulation flange passed the high-voltage test of 15 kV, while the leakage current is less than 1 mA after the improvement. More detailed test results will be shown in this paper.

Research on the Test Method of Dynamic Current Sharing Test for ITER PF Converter

Research and Development of the High-Power High-Current Polodial Field Converter Module

Dynamic Stability Analysis of High-Power DC Reactor for ITER Poloidal Field Converter

Full Scale Prototype Research and Development of the Iter Pf Converter Unit

Eddy Current Heating Effect of High-Current DC Reactor Applied to ITER Poloidal Field Converter

Electromagnetic compatibility analysis and design of ITER Poloidal Field converter unit

Study on the Four Quadrants Operation of ITER Poloidal Field Converter System

Installation Design and Integration of Poloidal Field Converter Units for ITER

Analysis and verification of electrodynamic force, thermal stress and current sharing for CRAFT converter structure design

High Voltage Test of Iter Feeder Components under Paschen Condition

Preliminary Design and Analysis of the DC Reactor for the ITER Converter

A method of DC short-circuit analysis and thyristor determination for high power nuclear fusion converter

Cold Performance Tests of the ITER 68 Ka HTS Current Lead Prototypes

Optimal Design and Test of the 68 Ka HTS Current Lead for ITER at CASIPP

Factory Acceptance Test of 50-Ka HTS Current Leads for the ITER CS Magnet Test Application

R&D ON A 68 kA HTS CURRENT LEAD FOR ITER PROJECT

A New Method for Current Distribution Study in the 6-in IGCT

Equivalent test of current limiting characteristics of 500 kV current limiter based on high coupling reactor

Analysis of Anti-Short Circuit Strength on Windings for ITER-PPEN Power Transformer

Study on the Current-Sharing Control System of the Tf Power Supply for A Superconducting Tokamak

Exploring Methods for Short Circuit Testing of High Voltage Fault Current Limiter Based on High Coupling Split Reactors