Abstract:In this paper, the fretting wear behaviour of steel wires working in coal mining technology is studied numerically. In past studies, the fretting process of steel wires was carried out numerically considering that the coefficient of friction (COF) and wear coefficient (WC) are constant parameters. However, it has been noticed experimentally that COF increases up to a certain number of fretting cycles and then becomes constant, i.e. a steady-state stage, depending on the loading conditions. This increase in COF during the fretting process is also known as the running-up stage. The fretting wear model is modified to evaluate the influence of the varying coefficient of friction (VCOF), which is associated with the variable wear coefficient (VWC), so the influence of VWC is also considered. The subroutine UMESHMOTION used to implement the wear law is also modified to study the effect of VCOF and VWC. Therefore, in this study, the numerical results of a three-dimensional finite element (FE) model are compared, with analytical results of contact area and contact stresses, and with experimental results of peak wear depth. After validating the FE model, the wear scar, the increasing wear depth, wear volume, and the decreasing contact stress with increasing fretting cycles are determined numerically considering VCOF and VWC using cycle jump approach. The energy dissipation effect of frictional force and fretting amplitude is also studied for varying interaction properties of fretting wear models. The numerical simulations are performed by considering both elastic and plastic material properties to analyse the influence of varying interaction properties on fretting wear models at the running-up stage. The results indicate that the VWC model exhibits comparable impacts on both the elastic and plastic models. The results also show that the VWC fretting wear model leads to higher wear scar, wear volume, and wear depth values at the running-up stage as well as at the steady state stage, which are close to the experimental data.

Fretting Wear Modelling Incorporating Cyclic Ratcheting Deformations and the Debris Evolution for Ti-6Al-4V

A Debris Layer Evolution-Based Model for Predicting Both Fretting Wear and Fretting Fatigue Lifetime

Modeling and simulation of wear for alignment mechanism of large aircraft component

Study of fretting wear mechanisms of complete contacts

Dynamic changes of mechanical properties induced by friction in the Archard wear model

Modeling adhesive and abrasive wear phenomena in fretting interfaces: A multiphysics approach coupling friction energy, third body and contact oxygenation concepts

Finite element analysis of fretting wear considering variable coefficient of friction

Fretting wear evolution of γ-TiAl alloy

Subsurface deformation mechanism and the interplay relationship between strength-ductility and fretting wear resistance during fretting of a high-strength titanium alloy

+Fretting wear: A phenomological approach

Simulation of fretting wear in steel wires under variable coefficient of friction and variable wear coefficient

Heterogeneity in tribologically transformed structure (TTS) of Ti-6Al-4V under fretting

A Peridynamic Frictional Contact Model for Contact Fatigue Crack Initiation and Propagation

Dependence of fretting wear on the microstructure characteristics and impact on the subsurface stability of a metastable β titanium alloy

Ti-6Al-4V fretting wear and a quantitative indicator for fretting regime evaluation

Contact Analysis of Abrasive Wear

Electrical contact resistance endurance of AgNi10 alloys under fretting wear: Experiment and numerical prediction

Establishment of high-temperature fretting wear prediction model for metal rubber with complex helical network structure

Variable cycle fretting conditions meditated wear behavior and mechanism in a self-lubricating composite coating on TC21 titanium alloy substrate

Coupling fractal model for adhesive and three-body abrasive wear of AISI 1045 carbon steel spool valves

A mechanistic model for the growth of cylindrical debris particles in the presence of adhesion