Abstract:Direct tip position regulation of flexible manipulators is one of the most challenging control tasks. There are mainly three problems to be addressed in order to achieve good performance. The first two control problems arise owing to the unstable zeros and complex poles in the system nominal part which is dominated by a transfer function. The third problem is the existence of unstructured uncertainties owing to the truncation of high-order resonance modes and system nonlinearities. Because of the above difficulties and in particular the non-minimum-phase nature, tip regulation task of flexible manipulators is usually solved indirectly: direct control of joint angle and suppression of the flexible link vibration. The aim of this study is to investigate the direct approach for tip regulation. Since the tip transfer function contains unstable zeros and the first few dominant flexible modes (complex poles), a reference model of the same order is selected which does not have any finite zero but all negative real poles. In order to force the system to follow the reference model in the presence of the unstructured uncertainties, a variable structure controller is adopted in which the switching surface is derived from the reference model. When in sliding mode, the system performs as the reference model. Hence there will be no vibration and the tip position regulation can be achieved when the system approaches steady state. To improve the system responses further, an adaptation law with dead-zone scheme is combined with the variable structure controller. Simulation results show that link vibrations have been eliminated and the control profile is fairly smooth.

Backstepping Control of Flexible Joint Manipulator Based on Hyperbolic Tangent Function with Control Input and Rate Constraints

Trajectory Tracking Control of A Hydraulic Parallel Robot Manipulator with Lumped Disturbance Observer

Dynamic Modeling and Trajectory Tracking Control of a Novel Muck-Removal Hydraulic Manipulator

A Simple Method Of Tip Trajectory Control For The Flexible Multi-Link Manipulator With Uncertain Parameters

A Generalized Trajectory Tracking Controller for Robot Manipulators with Bounded Inputs

Decoupled Dynamic Model and Control of Flexible Space Manipulator

An Adaptive Discrete Integral Terminal Sliding Mode Control Method for a Two-Joint Manipulator

A new control method of flexible-joint manipulator with harmonic drive

Adaptive PID Saturate Output Feedback Control of Robot Manipulators

Fast and Accurate Tracking Control of Robotic Manipulators Subject to State Constraints and Input Saturation by Effectively Integrating Planning Strategies

A model-based PID-like motion control method for flexible-joint manipulator with harmonic drives

Tracking control of a flexible‐link manipulator based on an improved barrier function adaptive sliding mode

Model-Free Control of Flexible Manipulator Based on Intrinsic Design

Direct Tip Regulation of a Single-Link Flexible Manipulator by Adaptive Variable Structure Control

Robust Backstepping Control Of Flexible-Link Manipulators Using Neural Networks

A novel hybrid observer‐based model‐free adaptive high‐order terminal sliding mode control for robot manipulators with prescribed performance

Adaptive sliding mode robust control of manipulator driven by tendon-sheath based on HJI theory

Point-to-point virtual model control of a flexible joint robotic manipulator using trajectories of motion

The Position Control Method of two Joint Manipulator Based on Sliding Mode and Trajectory Setting Algorithm of Quintic Polynomial Interpolation

Optimal Control And Design Of Flexible Manipulators Based On H-Infinity Controller

Drift Suppression Control Based on Online Intelligent Optimization for Planar Underactuated Manipulator With Passive Middle Joint