Abstract:In response to the trajectory tracking control problem of manipulators under measurement disturbances, a novel multi-input multi-output discrete integral terminal sliding mode control scheme is proposed. Initially, this scheme establishes a dynamic model of a two-joint manipulator based on the Lagrangian dynamics analysis method. Subsequently, a discrete integral terminal sliding mode control law based on the dynamic model of the two joints is designed, incorporating delayed estimation of unknown disturbances and discretization errors in the manipulator system. To enhance the trajectory tracking accuracy of the control scheme and suppress the impact of sliding mode chattering on the manipulator system, an adaptive switching term is introduced into the discrete integral terminal sliding mode control law. The paper derives an adaptive discrete integral terminal sliding mode control scheme and provides stability proof for the proposed approach. Simulation experiments are conducted to compare the proposed adaptive discrete integral terminal sliding mode control scheme with classical discrete sliding mode control schemes and discrete integral terminal sliding mode control schemes. The simulation results demonstrate that the designed adaptive discrete integral terminal sliding mode control scheme maintains trajectory tracking errors within 0.004 radians for each joint of the manipulator, with minimal changes in control torque for each joint. The absolute integral of the control torque variations is calculated at 5.85×103, which is lower than other control schemes, thereby validating the effectiveness and superiority of the proposed approach.
What problem does this paper attempt to address?
The paper mainly addresses the trajectory tracking control problem of a two-joint robotic arm under measurement disturbances by proposing a new multi-input multi-output (MIMO) discrete integral terminal sliding mode control method.
Specifically, the main contributions of the paper are as follows:
1. **Proposed a novel adaptive discrete integral terminal sliding mode control algorithm (ADITSMC)**:
- This algorithm uses a one-step delay estimation method to compensate for unknown disturbances in the controlled object;
- Introduces the concept of adaptive control to improve the trajectory tracking accuracy of the robotic arm system and suppress system chattering.
2. **Advantages compared to existing methods**:
- Compared to previous robust control, neural network, and fuzzy control methods, this scheme has a simpler controller design and higher tracking accuracy;
- Suitable for multi-input multi-output systems, thus providing higher system accuracy;
- Does not require a state observer, and the data-driven control algorithm is insensitive to system parameter changes, maintaining high tracking accuracy;
- Exhibits less chattering in the presence of high disturbances;
- Requires fewer parameters to be adjusted and can achieve slightly higher tracking accuracy.
3. **Theoretical analysis and proof**:
- The paper provides a stability proof of the proposed control method and elaborates on how to ensure the system enters a quasi-sliding mode state by designing appropriate sliding mode surfaces and control laws. This means that although the state cannot strictly lie on the sliding mode surface, it can move within a certain region near the sliding mode surface, maintaining an approximate sliding mode state, thereby achieving the goal of trajectory tracking control.
4. **Simulation verification**:
- Through simulation experiments on a two-joint robotic arm, the effects of the proposed adaptive discrete integral terminal sliding mode control method (ADITSMC), the traditional discrete integral terminal sliding mode control method (DITSMC), and the classic discrete sliding mode control method (DSMC) were compared.
- The results show that ADITSMC outperforms DITSMC in terms of trajectory tracking accuracy, while the DSMC scheme exhibits significant oscillations and chattering.
In summary, this paper aims to solve the high-precision trajectory tracking control problem of robotic arms under complex working conditions and verifies the effectiveness and superiority of the proposed adaptive discrete integral terminal sliding mode control method through theoretical analysis and simulation experiments.