Abstract:The micro-electro-mechanical system (MEMS) resonator developed based on surface processing technology usually changes the section shape either due to excessive etching or insufficient etching. In this paper, a section parameter is proposed to describe the microbeam changes in the upper and lower sections. The effect of section change on the mechanical properties is studied analytically and verified through numerical and finite element solutions. A doubly-clamped microbeam-based resonator, which is actuated by an electrode on one side, is investigated. The higher-order model is derived without neglecting the effects of neutral plane stretching and electrostatic nonlinearity. Further, the Galerkin method and Newton⁻Cotes method are used to reduce the complexity and order of the derived model. First of all, the influence of microbeam shape and gap variation on the static pull-in are studied. Then, the dynamic analysis of the system is investigated. The method of multiple scales (MMS) is applied to determine the response of the system for small amplitude vibrations. The relationship between the microbeam shape and the frequency response is discussed. Results show that the change of section and gap distance can make the vibration soften, harden, and so on. Furthermore, when the amplitude of vibration is large, the frequency response softening effect is weakened by the MMS. If the nonlinearity shows hardening-type behavior at the beginning, with the increase of the amplitude, the frequency response will shift from hardening to softening behavior. The large amplitude in-well motions are studied to investigate the transitions between hardening and softening behaviors. Finally, the finite element analysis using COMSOL software (COMSOL Inc., Stockholm, Sweden) is carried out to verify the theoretical results, and the two results are very close to each other in the stable region.

Study of Amplitude Saturation in T-Shape MEMS Resonators

Study on Nonlinear Acoustic Waves in Stepped Acoustic Resonators

Tuning vibration frequencies with shape memory alloys in precision engineering applications

Nonlinear dynamics of shape memory alloy oscillators in tuning structural vibration frequencies

Numerical Investigation Of Modal Amplitude Saturation In Micromechanical Cantilever Beam Resonators

Amplitude Deflection in a Nonlinear MEMS Resonator under Parametric Excitation

The Recent Progress of MEMS/NEMS Resonators

MEMS-based mechanical AGC for oscillator circuits

Probing Linear to Nonlinear Damping in 2D Semiconductor Nanoelectromechanical Resonators Toward a Unified Quality Factor Model.

A State-Space Phase-Noise Model for Nonlinear MEMS Oscillators Employing Automatic Amplitude Control

Nonlinearity Reduction in MEMS Resonators Based on Design of H-shaped Beams

Frequency Stabilization in a Pseudo-Linear Micromechanical Parametric Oscillator

Static and Dynamic Mechanical Behaviors of Electrostatic MEMS Resonator with Surface Processing Error

Control of Spring Softening and Hardening in the Squared Daisy

Enhanced Frequency Stability In A Non-Linear Mems Oscillator Employing Phase Feedback

Suspended Gate Field Effect Transistor Type Microelectromechanical Systems Resonators Modelling with Micro-Raman Spectroscopy Measured Residual Stress

Nonlinearity-Induced Asymmetric Synchronization Region in Micromechanical Oscillators

Anomalous Amplitude-Frequency Dependence in a Micromechanical Resonator under Synchronization

Sensitivity Enhancement of Nonlinear Micromechanical Sensors Using Parametric Symmetry Breaking

Dynamics of large oscillations in electrostatic MEMS

On Extending Signal-to-Noise Ratio of Resonators for a MEMS Resonant Accelerometers Using Nonlinearity Compensation