Abstract:The topic of VSG grid voltage fault ride through has drawn increasing attention as virtual synchronous generator (VSG) technology has been widely applied in the field of renewable energy power generation. Due to the delay of the reactive power compensation device after the low-voltage fault recovery, the high-voltage fault will happen immediately after the grid's low-voltage fault is resolved. This phenomenon is known as low and high voltage cascading faults. There is not enough research on this specific voltage fault right now. For specific investigation, the low and high voltage cascading faults in this paper are separated into low-voltage fault stages and high-voltage fault stages. The equal area criterion (EAC) is used to analyze the specific process at the low-voltage fault stage. In addition, the dynamic damping control (DDC) is utilized to resolve the problem of low-voltage fault stability. Under low voltage fault, the phase portrait studies the single-period stability with an equilibrium point in a single-period and the multi-period stability without an equilibrium point in a single-period, respectively. Using a phase portrait to analyze system performance during a high voltage fault, and a virtual capacitor feedback control (VCFC) is offered to effectively reduce active power overshoot due to high voltage fault. The EAC is used to analyze the specific process of the high voltage stage, it is concluded that there is always an equilibrium point in the high-voltage fault where IGBT limitations are ignored. Finally, the correctness and feasibility of the theory are verified by simulation, and the specific analysis results are given.

Comparison of Current-Limiting Strategies of Virtual Synchronous Generator Control During Fault Ride-Through

A Novel Fault Ride Through Strategy for Grid-Connected Virtual Synchronous Generators: Power Angle Stability Enhancement and Current Limiting

Improved Virtual Synchronous Generator Control of DFIG to Ride-Through Symmetrical Voltage Fault

Control of Doubly-Fed Induction Generator to Ride-Through Recurring Grid Faults

Control Method for Fault Ride-through of DFIG-based Wind Turbines Applied to Weak Grids

Fault Ride-Through Control of Grid-Connected Photovoltaic Power Plants: A Review

Fault Ride-Through Control Strategy for Single-Phase Virtual Synchronous Generator

A Fault Ride-through Method of VSG Based on Reactive Power Feedback Coefficient Optimization

Enhancement of Low-Voltage Ride-Through Capability for Virtual Synchronous Generators Based on Virtual Impedance Voltage Control

Transient Stability Enhancement of Current Limited-GFM Inverters Based on Varying Virtual Impedance

Virtual Synchronous Control Strategy for Doubly-Fed Induction Generator under Asymmetrical Grid Faults

Comparison of control strategies for Doubly fed induction generator under recurring grid faults

Design-Oriented Analysis and Transient Stability Enhancement Control for a Virtual Synchronous Generator

Overvoltage ride through control strategy for improving voltage support capability of virtual synchronous generator

Improved transient stability of virtual synchronous generators for grid voltage cascading faults

A Dynamic Strategy To Improve The Ride-Through Capability Of A Fixed Speed Induction Generator

A combined regulation method of transient power angle stability control and fault current suppression for VSG

Fault-ride Through Control Strategy of Multi-terminal High Voltage DC Systems

LVRT Control Method of Virtual Synchronous Generator Based on Mode Smooth Switching

Adaptive low voltage crossing strategy for symmetrical faults of networked inverters

A New Control Strategy For Improving Low Voltage Ride Through Capability Of Dfig