Abstract:A control strategy aimed at enhancing the voltage support capabilities of virtual synchronous generators during overvoltage scenarios was proposed. This method augments the reactive power absorption capacity of VSG, thereby suppressing transient overvoltage. As the application of renewable energy sources continues to increase, the virtual synchronous generator (VSG) has been proposed and received widespread attention. In China, new energy stations are typically situated at the transmission end of LCC‐HVDC lines. A failure in DC commutation can lead to overvoltage at the DC transmission end, thus posing a significant risk of disconnection from the grid due to the occurrence of overvoltage. Compared to when low‐voltage occur, it was discovered that, during overvoltage, VSGs face difficulties in rapidly attaining the preset power and transient instability. These issues can significantly impact the voltage support capability of the VSG. To address these concerns, an enhanced control strategy has been proposed. The control strategy sets reasonable power reference values, leveraging the advantage of fast voltage response in VSG by matching its voltage with virtual impedance. This ensures that the power rapidly reaches the designated reference value while reducing fluctuations in power angle. The transient power‐angle stability is validated using the energy function method. This approach enhances the reactive power absorbed by VSG, thereby mitigating transient overvoltage. Finally, simulation results from PSCAD/EMTDC validate the rationale and effectiveness of the control strategy.

LVRT Control Method of Virtual Synchronous Generator Based on Mode Smooth Switching

A Fault Ride-through Method of VSG Based on Reactive Power Feedback Coefficient Optimization

Improved Power Decoupling Control Strategy Based on Virtual Synchronous Generator

Low Voltage Ride-Through of Two-Stage Grid-Connected Photovoltaic Systems Through the Inherent Linear Power-Voltage Characteristic

A hybrid LVRT control scheme for PMSG wind power system

General Control Strategy to Limit Peak Currents of Virtual Synchronous Generator under Voltage Sags

Design of VSG testbed for LVRT of renewable energy

Flexible Unbalanced Control with Peak Current Limitation for Virtual Synchronous Generator under Voltage Sags

Improved Virtual Synchronous Generator Control of DFIG to Ride-Through Symmetrical Voltage Fault

Overvoltage ride through control strategy for improving voltage support capability of virtual synchronous generator

A Low Voltage Ride Through Control Strategy for PMSG Based on Electromechanical Energy Storage

A Three-Phase Programmable Voltage Sag Generator for Low Voltage Ride-Through Capability Test of Wind Turbines

A Novel Fault Ride Through Strategy for Grid-Connected Virtual Synchronous Generators: Power Angle Stability Enhancement and Current Limiting

State Feedback Exact Linearization Control of Virtual Synchronous Generator to Improve Transient Performance

Enhancement of Low-Voltage Ride-Through Capability for Virtual Synchronous Generators Based on Virtual Impedance Voltage Control

Comprehensive Control Strategy of Virtual Synchronous Generator under Unbalanced Voltage Conditions

A Novel Power-Flow Balance Lvrt Control Strategy For Low-Speed Direct-Drive Pmsg Wind Generation System

A Distributed VSG Control Method for a Battery Energy Storage System with a Cascaded H-bridge in a Grid-Connected Mode

Reserach on VSG LVRT Control Strategy of Photovoltaic Storage Microgrid

Using Virtual Synchronous Generator Control Based Energy Storage to Enhance the Stability of Sending Terminal in LCC-HVDC System

Fault Ride-Through Control Strategy for Single-Phase Virtual Synchronous Generator