Abstract:Purpose. Research of cutting force components during machining of high-hard cast iron by special prefabricated cutters with brazed niborite and ciborite inserts. Determination of the influence of geometric characteristics of the cutting tool, cutting modes and hardness of the material being machined on the cutting forces. The methods. The research methods were based on the fundamentals of cutting theory and cutting tools, material science properties of the tool and processed material. A research bench with special equipment was used. Findings. The nature of the change in the components of cutting forces with depth t, feed rate S and cutting speed v was experimentally investigated. The studies have shown an excess of the resulting force in the horizontal plane Pv over the circumferential one Pz, which is the main feature of turning high-hard metals. It has been established that the main limiting factors in the wear of tool cutting inserts are the permissible levels of forces. The hardness of HB has the greatest effect on the radial force Py. Under identical turning conditions for materials with a hardness of 220 to 610 HB, the forces Pz, Py and Px increase by 1,7; 3,3 and 2,3 times, respectively. In addition to the natural increase, the ratio of cutting forces also changes. Reducing the front angle of the blade causes a deterioration in chip formation conditions and leads to an increase in all components of the cutting forces. An increase in the radius at the top of the cutter r causes an increase in the width and decrease in the thickness of the layer to be cut, as well as a decrease in the main angle in the plan φr on the radial part of the blade. The originality. A complex dependence in the structural-stage form was obtained, which gives a clear picture of the influence of each parameter of the turning process on its performance. This dependence is a mathematical model for calculating the optimal operating and geometric parameters of the turning process of high-hard cast irons. The influence of the frontal angle γ, wear value h, and hardness of HB cast iron on the power characteristics during machining of high-hard cast irons has been studied. Practical implementation. It has been shown that it is economically advantageous to maximize the wear of cutting inserts made of relatively expensive composites. In this case, it is necessary to use a technological system of machine-workpiece-tool of high rigidity.

Cutting performance of cemented carbide cutting tool in turning high‐density fiberboard

Wear Behaviors of Pcd Tools in Turning Granite

Influence of cutting parameters on PCD tool wear during milling tungsten carbide

Research on cutting parameters of low-temperature liquid CO 2 assisted PCD tool turning bearing ring

Effect of cutting tool with micro-pits texture on wood cutting performance

Inlfuences of Material Tool and Tool Wear on Cutting Temperature of Turning Titanium Matrix Composites

Influence of cryogenic CO2 on wood-plastic composite (WPC) turning-performance characteristics: a comparison with dry machining

Cutting Performance and Wear/Damage Characteristics of PCBN Tool in Hard Milling

Cutting performance and wear behavior of diamond, coated cemented carbide and PCBN tools during milling of C f /SiC composites

The Study on the Effect of Various Tool Wear Indicators on the Machining of MMCs

Machinability of Different Wood-Plastic Composites during Peripheral Milling

Wear performance and mechanisms of PCBN tools in boring of powder metallurgy steels

Cutting performance and tool wear mechanism of corrugated helical PCD tool in milling Cf/SiC composites

Study of cutting forces during turning of high-hard cast irons

Effects of Milling Methods on Cutting Performance of Wood–Plastic Composites Based on Principal Component Analysis

Cutting performance of cubic boron nitride-coated tools in dry turning of hardened ductile iron

Wear mechanism and cutting performance evaluation of fine ceramic tools

Cutting forces and cutting quality in the up-milling of solid wood using ceramic cutting tools

Performance analysis of conventional and high-feed turning tools in machining the thermally affected zone after plasma arc cutting of low carbon manganese-alloyed steel

Comprehensive Evaluation Analysis and Optimization Methodology of Tool Geometric Parameters for High Speed Cutting

Study on 3D topography of machined surface in high-speed hard cutting with PCBN tool