Abstract:In the absence of flux measurements, techniques of field orientations depend on motor parameters, particularly on rotor resistances. During operation in flux-oriented mode, online continuous estimation of harmonic and fundamental rotor resistances is important for multiphase IM. To limit the core saturation and to achieve the synchronous and aligned air-gap flux density distribution, the harmonic plane is based on magnetizing flux-oriented control (MFOC) whereas the fundamental plane is taken as rotor flux-oriented control (RFOC). Mismatch harmonic and fundamental resistances trigger deviations in the rotor and magnetizing flux and also cause misalignment in the resultant induced electromotive force (EMF) waveform which could, in turn, be the reason for over-excitation and under-excitation. This article formulates the simultaneous online identification of rotor resistances for particularly MFOC harmonic plane while the fundamental plane is RFOC based on the dot product of rotor flux and stator current for making a model reference adaptive system (MRAS). Mismatched stator resistance and dead time of inverter have a negligible effect on the reference model during steady state. Convergence and steady-state performance can be acquired for a variation of load conditions particularly at heavy loading. The validation of the proposed approach is verified through simulation and experiment results by incorporating a multiphase platform consisting of a seven-phase induction machine.

Rotor Position Detection Method at Zero or Low Speed for Electrically Excited Synchronous Motor

Permanent Magnet Linear Synchronous Motor Mover Position Estimation at Zero and Low Speed Using Eddy Current Loss Equivalent Resistance

Sensorless Control Strategy for Multiphase Induction Motor with Stator and Rotor Resistance Identification Based on Injecting Third Harmonic Current

Online Sensorless Position Estimation for Switched Reluctance Motors Using One Current Sensor

Harmonic and Fundamental Rotor Resistance Estimation Scheme for Multiphase Induction Motor Based on Nonsinusoidal Supply Control

A Current Product Signal Analysis Method For Rotor Fault Diagnosis In Induction Motors

An Improved Rotor Position Estimation Method for PMSM Using Low-Resolution Hall-Effect Sensors

Speed Sensor-Less Control of an Induction Motor with Rotor Flux Tracking at Very Low Speed

Wave-Form Detection Technique for Indirect Rotor-Position Sensing of Switched-Reluctance Motor-Drives .2. Experimental Results

Waveform Detection Technique for Indirect Rotor-Position Sensing of Switched-Reluctance Motor Drives. I. Analysis

Diagnosis of Broken Rotor Bar Fault in Open- and Closed-Loop Controlled Wye-Connected Induction Motors Using Zero-Sequence Voltage

Direct Rotor Position Detection Method for Sensorless Brushless DC Motors

Research of Sensorless Control for Multiphase Induction Motor Based on High Frequency Injection Signal Technique

Sensorless Control for Five-phase Induction Motors With Improved Third-harmonic Current Injection

Initial Rotor Position Detection of Permanent Magnet Synchronous Motor Based on Oscillating Voltage

Stator Inter-Turn Fault Detection in Closed-Loop Controlled Drive Based on Switching Sideband Harmonics in CMV

Online Identification of Inductance and Flux Linkage for SPMSMs Decoupled from Resistance Voltage Drop and VSI Nonlinearity

Harmonic Suppression For Low Speed Sensorless Control of SPMSM Based on High Voltage Frequency Pulsating Signal Injection

Rotor Incipient Position Detection of Rotor for PMSM Based on High Frequency Current Injection

Initial Rotor Position Detection for Permanent Magnet Synchronous Motor Based on High-Frequency Voltage Injection without Filter

Online Inductance Identification of Permanent Magnet Synchronous Motors Independent of Rotor Position Information