Abstract:Introduction Laser peen forming (LPF) is a forming technique using laser-induced plasma to impact the workpiece spot-by-spot and forming the metal sheet into a specified curvature. It is a complex physics process including laser ablation, shock wave propagation, material yielding and deformation accumulation. A high-intensity short-pulsed laser irradiates on the surface of the workpiece, as a result, high pressure plasma generates on the surface of the workpiece in the confinement of water. In the impact of high pressure plasma, the shock pressure generates and spreads to the depth direction. The amplitude of the shock wave arrives at 1-10 GPa and the time duration is around 100 nanoseconds, as a consequence LPF is a high-dynamic response process due to the laser shock process. When the shock wave exceeds the Von Mises stress of materials, the workpiece in the shock zone yields and generates plastic strain. After laser scanning over the workpiece surface, the deformation is accumulated with the expanding of the plastic zone, resulting in the workpiece bending into a small curvature convex shape. In order to overcome the difficulty of improving the pulse energy, laser-assisted laser peen forming(LALPF) was proposed by Hu et al. [1] to improve the bending capability. LALPF adapted CW laser heating to increase the deformation. Laser heating plays an assisted role in softening the material and altering the stress state of material during LALPF. Simutationly, the back surface of the workpiece is heating by continuous wave (CW) laser which is coaxial with the pulsed laser. The material absorbs the CW laser energy resulting in high temperature field in the local area. The local high temperature decreases the yield strength, inducing thermal stress even plastic thermal strain owing to the nonuniform expansion of material. Thus, lager and deeper plastic strain is generated in the laser shock process and the deformation of the workpiece increase compared with the LPF in room temperature.

Distortion Control of Thin Sections by Single-Sided Laser Peening

Geometry distortion and residual stress of alternate double-sided laser peening of thin section component

Analytical Modeling of Axis Geometry Effect in Laser Peen Forming

Investigation on the bending deformation of laser peen forming with a simplified eigenstrain-based finite element model

Process-based Surface Flattening Method for Laser Peen Forming of Complex Geometry

Experimental Investigation of Double-Side Laser Peening of Thin-Wall Parts With Alternate Side Laser Scanning

Plastic Deformation Mechanisms and Their Threshold Pressures of Ti6Al4V Thin-Walled Structures Induced by Laser Peen Forming

Simulation of the elasto-plastic response and residual stresses near metal surface due to laser shock processing

Parameter Optimization for Laser Peen Forming on 6005A-T6 Aluminum Alloy Plates to Enhance the Constrained Deformation of Integral Stiffened Plates

Theoretical and Experimental Study on Laser Compound Forming of Plate

Visual Study on Surface Micro-Topography and Residual Stress of Sheet Metal after Pulsed Laser Peening

Numerical modelling of deformation prediction for laser-assisted laser peen forming

Quantitative Evaluation of Specimen Geometry Effect on Bending Deformation of Laser Peen Forming

Process Planning for Laser Peen Forming of Complex Geometry: an Analytical-Based Inverse Study

Three-dimensional numerical simulation and experimental study of sheet metal bending by laser peen forming

Laser Forming of Doubly Curved Plates Using Minimum Energy Principle and Comprehensive Strain Control

Surface Evenness Control of Laser Solid Formed Thin-Walled Parts Based on the Mathematical Model of the Single Cladding Layer Thickness

A review of low plasticity burnishing and its applications

Recent Progress in Laser Peen Forming of Large Scale Panel

Optimization Of Residual Stresses Induced By Multiple Laser Shock Processing

Study on processing strategy of singly curved surface based on plastic strain field in laser forming