Abstract:& nbsp;Considering electrical control of electrostatic precipitation, this paper discusses particle collection in terms of corona ionic wind, gas flow pattern and high-voltage power sources. Experiments and simulations were conducted with lab-scale and industrial electrostatic precipitators. In general, a larger electrostatic precipitator (ESP) index value leads to better ESP performance. To maintain the voltage, simulation results show that a three-phase power source could operate at a lower ripple factor of 0.8% and a shorter recovery time of 5 ms after spark-over than single-phase or high frequency transformer rectifiers. For an industrial ESP with several electric fields, optimal voltage or electric field strength drops from its inlet to outlet fields. It is normally around 3.3 kV cm(-1) with a large corona input power for the inlet field, and it drops to about 2.3 kV cm(-1) with a small input power to limit ionic wind induced reentrainment for the last field. For a typical Chinese 660 MW coal-fired boiler with a fourfield colder-side ESP, its outlet ash concentration and its PM10 and PM2.5 are usually around 15 mg m(-3), 12 mg m(-3) and 2 mg m(-3), respectively. According to particle image velocimetry observation and particle collection measurements, we found that the corona wind generated vortex can result in not only enhancement of collection but also particle reentrainment and/or the so-called 'bypass flow'. An optimum electric field inside the ESP exists to save energy and collect particles. For present ESPs, a higher electric field (>3.5 kV cm(-1)) generates strong electrohydrodynamic flow, which consequently undermines the collection due to turbulent flow. Advanced industrial automatic voltage controllers for three-phase transformer rectifier and double-wire ESPs have been developed according to those experimental results for both reducing emission and corona energy consumption.

Control and Protection Strategy Design of IGBT Switch for Pulsed Electrostatic Precipitators

A High-Voltage Solid-State Switch Based On Series Connection Of Igbts For Pef Applications

Electrical Control of Electrostatic Precipitation

A High Speed Short-Circuit Protection Circuit with Current Limitation and Soft Turn-Off for High Power IGBTs

Advanced Active Gate Drive for Switching Performance Improvement and Overvoltage Protection of High-Power IGBTs

A voltage controlled current source gate drive method for IGBT devices

Improved Control Strategy of an Active Crowbar for Directly-Driven PM Wind Generation System under Grid Voltage Dips

A Novel Gate Control Strategy for 3.4kv Cascade Sic Mosfets Stack

Design and Simulation of a Compact High-voltage Pulse Power Supply Using Solid-state Switches

Overvoltage Protection of High Power IGBTs in Wind Power Converters under Short Circuit

Method of drive and rapid protection for high power IGBTs

A Simple Online Fault Location and Tolerant Control Strategy for Power Electronic Transformers with a Single IGBT Open-Circuit Fault

Analysis of IGBT Pseudodesaturation Effect Caused by Stray Parameters in DC Circuit Breaker

Research of the Control Strategy for D.C Power Source Used in Artificial Pollution Test

Sensitivity Analysis and Suppression Method on PETT Oscillations under Short Circuit Condition of High-Power IGBT Modules

An Integrated Voltage and Current Balancing Strategy of Series-Parallel Connected IGBTs

A High Voltage Pulsed Power Supply With Magnetic Switch For Esp

Research of Controlled Switching Strategy to Restrain Inrush Current During the Energisation of Converter Transformer

A Real-Time Optimization Method for Economic and Effective Operation of Electrostatic Precipitators

An In-rush Current Suppression Technique for the Solid-State Transfer Switch System

A New Control Strategy for Converters Based on Hybrid Switch