Abstract:Based on the computer vision, optical non-contact measurement has been widely applied in the field of mechanical vibration measurement. However, existing computer vision methods are primarily suitable for on-site vibration scenarios, which pose significant technical challenges for combined scenarios involving both rotation and vibration. When measuring high-speed test points, the simplest and most direct approach is to use high-frame-rate image acquisition devices. This paper adopts a gradient-based optical flow tracking and measurement technique to track points of interest on rotating structures. In order to overcome the limitation of optical flow method's “spatial continuity assumption” on the measurement speed of rotating structures, a novel optical tracking and measurement method for periodically rotating blades based on center marker recognition in reorganized videos is proposed. Building upon the optical flow-based target tracking and detection algorithm, an improved method based on Quick Response Code(QR Code) marker tracking and Phase Mapping Method (PMM) is proposed. The optical flow method for rotating structures achieves an increased maximum detection speed, thereby reducing the cost of image sampling devices. In theory, the maximum detectable rotational speed that can be increased depends on the ratio of the length of the blade (R) to the adopted two-dimensional side length (r), denoted as R/r. In this paper, the theoretical maximum value for the increased rotational speed is R/r≈4. Compared to high-frame-rate cameras with costs ranging from tens of thousands to even several hundred thousand dollars, the commercial camera devices used in this paper are priced at around a few thousand dollars. On the other hand, the use of QR Code for marking and tracking improves the accuracy of the detection algorithm and allows for the inclusion of more information within the QR Code. The paper introduces and analyzes the fundamentals and principles of this algorithm, conducts experimental measurements, and verifies the proposed improvement through theoretical calculations.

Vision-based system for simultaneous monitoring of shaft rotational speed and axial vibration using non-projection composite fringe pattern

Real-time Three-Dimensional Vibration Monitoring of Rotating Shafts Using Constant-Density Sinusoidal Fringe Pattern As Tri-Axial Sensor

Measurement of Instantaneous Rotational Speed Using Double Sine-Varying-density Fringe Pattern

A High-Frequency Angular Vibration Calibration System Based on Phase Modulated Laser Interferometer Technique

Three-dimensional translation vibration measurement system based on linear array sensor and composite fringe pattern

Monitoring of structural dynamic behaviors by vision-based system *

Optical Inertial Vibration Sensor System Using Grating Technology

Identification of Structural Dynamic Characteristics Based on Machine Vision Technology

Transmission and measurement characteristics evaluation of surface acoustic wave sensor on rotating spindle in machine tools

A High-Speed Vision-Based Sensor for Dynamic Vibration Analysis Using Fast Motion Extraction Algorithms.

FBG-based non-contact vibration measurement and experimental study

Vision-based Measurement for Rotational Speed by Improving Lucas-Kanade Template Tracking Algorithm.

Tracking and measurement of periodic rotating blades after video recombination based on center mark recognition

Moiré fringes-based measurement of radial error motion of high-speed spindle

In Situ Diagnosis of Industrial Motors by Using Vision-Based Smart Sensing Technology

Binocular Vision-Based Method Used for Determining the Static and Dynamic Parameters of the Long-Stroke Shakers in Low-Frequency Vibration Calibration

Interference-enhanced micro-vision-based single-shot imaging of five degrees-of-freedom error motions for ultra-precision rotary axes

Uniaxial 3D Measurement with Auto-Synchronous Phase-Shifting and Defocusing Based on a Tilted Grating

On-line condition monitoring for rotor systems based on nonlinear data-driven modelling and model frequency analysis

Three-dimensional instantaneous orbit map for rotor-bearing system based on a novel multivariate complex variational mode decomposition algorithm

Simultaneous Measurement of Belt Speed and Vibration Through Electrostatic Sensing and Data Fusion.