Abstract:The radial and axial vibration signals of a rotating machine are crucial information to understand the machine operation and to diagnose potential faults. Instead of using three single sensors to measure the horizontal, vertical and axial displacements of rotating shafts, a novel non-projection vision-based system was proposed to realize simultaneous measurement of the radial and axial displacements with high accuracy and good reliability using an tailored artificial constant density sinusoidal fringe pattern (CDSFP), which was pasted around the shaft surface and worked as a tri-axial (i.e. the horizontal, vertical and axial) displacement sensor. The measurement principle and setup of the proposed measurement system were well established. The horizontal displacement could be correctly obtained from the fringe period density changes of the CDSFP image sequence recorded by a high-speed camera. Simultaneously, the vertical displacement could be acquired by tracking the centerline of shaft whilst the axial displacement could be obtained by locating the peaks of the cross-correlation sequence of the fringe intensities. A sub-pixel method was employed to improve the displacement resolution of the developed system. The performance of the proposed system was demonstrated by the comparison of the experiments using eddy current sensors. It showed that the proposed method was an effective and accurate technique for real-time tri-axial vibration monitoring of rotating shaft. Experimental results verified the feasibility, effectiveness and good robustness of the proposed methodology, which demonstrated that the proposed system was capable of achieving accurate tri-axial vibration displacements of rotating shaft compared to the commercial eddy current sensor which could only measure one dimensional displacement at each measurement. Therefore, the vision-based tri-axial vibration monitoring system could be recommended for real engineering applications in condition monitoring of rotating shafts. (C) 2018 Elsevier Ltd. All rights reserved.

Three-dimensional instantaneous orbit map for rotor-bearing system based on a novel multivariate complex variational mode decomposition algorithm

A New Procedure for Extracting Fault Feature of Multi-Frequency Signal from Rotating Machinery

A Novel Fault Diagnosis Method for Rotor-Bearing System Based on Instantaneous Orbit Fusion Feature Image and Deep Convolutional Neural Network

Research on Vibration Response of a Multi-Faulted Rotor System Using LMD-based Time-Frequency Representation

Morphological haar wavelet-based purification of rotor center's orbit

An optimized VMD method and its applications in bearing fault diagnosis

Instantaneous Amplitude-Frequency Feature Extraction for Rotor Fault Based on BEMD and Hilbert Transform

Rotating machinery early fault detection integrating variational mode decomposition and multiscale singular value decomposition

Weighted kurtosis-based VMD and improved frequency-weighted energy operator low-speed bearing-fault diagnosis

An Identification Method for Rotor Axis Orbits based on Enhanced Hierarchical Multivariate Fuzzy Entropy and Extreme Learning Machine

Multi-feature optimized VMD and fusion index for bearing fault diagnosis method

Three-Dimensional Hybrid Fusion Networks for Current-based Bearing Fault Diagnosis

Composite fault diagnosis for rolling bearing based on parameter-optimized VMD

An Improved Variational Mode Decomposition and Its Application on Fault Feature Extraction of Rolling Element Bearing

A Novel Method Based on Stepwise Variational Modal Decomposition and Gramian Angular Difference Field for Bearing Health Monitoring

A Dichotomy-Based Variational Mode Decomposition Method for Rotating Machinery Fault Diagnosis

Adaptive variational mode decomposition based on artificial fish swarm algorithm for fault diagnosis of rolling bearings

Real-time Three-Dimensional Vibration Monitoring of Rotating Shafts Using Constant-Density Sinusoidal Fringe Pattern As Tri-Axial Sensor

Empirical variational mode extraction and its application in bearing fault diagnosis

Fault Diagnosis of Variable Load Bearing Based on Quantum Chaotic Fruit Fly VMD and Variational RVM

A novel weak fault signal detection approach for a rolling bearing using variational mode decomposition and phase space parallel factor analysis