Abstract:Many applications, such as photovoltaic systems, uninterruptible power supplies, and automobile headlamps, need a high step-up DC–DC converter without isolation. The conventional boost converter has the advantages of simple topology and easy control. However, it has some shortcomings, such as insufficient step-up voltage ratio and poor efficiency when operating at large duty-cycle conditions. One of the popular topologies used to overcome these problems is the coupled-inductor boost converter. It utilizes the turn ratio of the coupled inductor to realize a higher step-up voltage ratio. The drawback is that the leakage inductance of the coupled inductor causes a huge voltage spike when the power switches are turned off. Moreover, because coupled inductors are characterized by their large volume and high profile, a conventional coupled-inductor boost converter is unsuited for photovoltaic systems, such as the solar microinverter. This study proposes a novel high-step-up boost converter to solve these problems. This proposed converter uses dual coupled inductors instead of the conventional coupled-inductor boost converter. The secondary side of the coupled inductor is connected in series to increase the step-up voltage ratio. The proposed converter utilizes active clamping to achieve zero-voltage switching (ZVS) for suppressing voltage spike and improving conversion efficiency. In addition, low-profile designs can be fulfilled easily for solar microinverters. The proposed converter and its control method are introduced. The operation principle, circuit characteristics, and circuit analysis are presented. A prototype converter with 300 W output power 25–40 VDC input voltage and 200 VDC output voltage was tested. All functions, including high step-up voltage ratio, ZVS, and active clamping, were achieved, and the highest efficiency was around at 94.7%.

ZVS Three‐phase Current‐fed Push–pull Converter Employing a Simple Active‐clamp Circuit for Voltage Step‐up Applications

Improved High Step-Up Dc-Dc Converter Based on Active Clamp Coupled Inductor with Voltage Double Cells

A New ZVCS Resonant Voltage-Fed Push-Pull Converter for Vehicle Inverter Application

A Zero-Voltage Switching Three-Phase Inverter

Zero-Voltage-Switching SiC-MOSFET Three-Phase Four-Wire Back-to-Back Converter

Performance Analysis of Single Phase High Step-Up Converter with Coupled Inductor Multiplier

Research of an Active Clamping Current-fed Half-bridge Converter with Input Parallel and Output Series

Single-Phase Single-Stage Isolated ZCS Current-Fed Full-Bridge Converter for High-Power AC/DC Applications

Current-Feed Single-Switch Forward Resonant DC Transformer (DCX) with Secondary Diode-Clamping.

Interleaved High Step-Up Converter with Coupled Inductor and Blocking Capacitor

Analysis and Design of Zero-Voltage-Switching Multiphase AC/DC Converters

Active-Clamp ZVZCS Resonant Forward DC Transformer (DCX) with Load-Adaptive ON-Time Control

An Active-Clamping Current-Fed Push-Pull Converter For Vehicle Inverter Application And Resonance Analysis

A ZVS-PWM Scheme for Three-Phase Active-Clamping T-Type Inverters

A hybrid ZVZCS phase-shift full-bridge converter with series/parallel auto-regulated transformer windings

Dual-Coupled-Inductor-Based High-Step-Up Boost Converter with Active-Clamping and Zero-Voltage Switching

An Interleaved Zero-Voltage Zero-Current Switching High Step-Up DC-DC Converter

A universal ZVS design for a family of quadratic boost converters

Zero-voltage Transition Interleaved High Step-Up Converter with Built-in Transformer

ZVS Three-Level Phase-Shift High Step-Down DC/DC Converter with Two Transformers

Newly Designed ZVS Multi-Input Converter