Abstract:Short particle residence time in the active area limits the engineering applications of impinging stream reactors. The single-particle residence time in the active area (t(tot)) is measured and compared among impulse impinging streams (IIS) in which both inlet velocities exhibit step variations during one period, asymmetric impinging streams (AIS) and symmetric impinging streams (SIS). In addition, the effects of the impulse inlet velocity conditions, the reactor geometry and the particle properties on the single-particle motion behaviors and trajectories in a coaxial impinging stream reactor are investigated and discussed in this study. T denotes the variation period of the impulse inlet flows. The results show that single particles with different particle relaxation time (tau*) exhibit different motion behaviors in an impinging stream reactor. A single particle with a short tau* is accelerated directly by the original fluid and leaves the active area without oscillatory motion in SISAIS and IIS. A single particle with a long tau* exhibits at most three oscillatory motions in SIS,AIS and IIS. However, a single particle with an even longer tau* exhibits only three oscillatory motions in SIS and AIS but at least three oscillatory motions in IIS. The t(tot) value in a coaxial impinging stream reactor generally varies with the inlet velocity conditions, the properties of the particles themselves and the size of the active area. In particular, at long tau*, the t(tot), value reaches a maximum in the IIS case when T = T-b. T-b is determined by tau*, Re-m and L/D. By contrast, at short tau*, the t(tot) values in SISIIS and AIS are all the same. However, at long tau*, the value of t(tot) is greater in the case of IIS at T = T-b than it is in the AIS case, increases with a decreasing inlet velocity ratio in the AIS case, and is the shortest in the SIS case under identical simulation conditions. On the whole, at long tau*, t(tot) and the particle motion distance in the active area can be significantly enhanced in the IIS case in comparison with the SIS and AIS cases at the same mean inlet velocity by reasonably designing the inlet velocity conditions. (C) 2018 Elsevier B.V. All rights reserved.

Distribution of Particle Resident Time in a Combined Coaxial Gas–solid Two-Phase Impinging Stream

Numerical Simulations of a Gas–Solid Two-Phase Impinging Stream Reactor with Dynamic Inlet Flow

Study of Single-Particle Residence Time in Impulse, Symmetric and Asymmetric Coaxial Impinging Streams

Simultaneous Measurements of Velocity and Concentration Fields in an Inclined Jet in Crossflow

Distribution and Movement of Fine Particles Injected in a Gas–solid Fluidized Bed with Hydrocarbon Liquid Spray

Flow Simulation and Experimental Study of a Dynamic Asymmetric Impinging Stream

Experimental and Numerical Studies on Flow and Turbulence Characteristics of Impinging Stream Reactors with Dynamic Inlet Velocity Variation

Particle-scale Simulation of Fluidized Bed with Immersed Tubes

Flow characteristics in a semi-confined circular-pipe impinging jet

Study of the drying characteristics in an asymmetric impinging stream reactor

Numerical Simulation of Hydrodynamics in Downers Using a CFD–DEM Coupled Approach

Direct simulation of interfacial flows for multi-phase and multi-component mixtures using the particle method

Experimental Investigation of Local and Average Heat Transfer Coefficients under an Inline Impinging Jet Array, Including Jets with Low Impingement Distance and Inclined Angle

Jet impingement using an adjustable spreading-angle sweeping jet

Upstream penetration of developed counter flow resulting from impingement of multiple jets in crossflow of cylindrical duct

Experimental Research on Fluidization Parameters of Air-Impingement Jet of Particulate Material

Numerical Investigation of the Time-Related Properties of Solid Phase in a 3-D Spout-Fluid Bed

Three-Dimensional Simulation of Turbulent Rectangular and Square Impinging Jet Flows

Flow regime transition and bubble behavior in gas-liquid two-phase impinging jet reactor

Effect of concave‐wall jets with circumferential multi‐inlet on liquid–solid separation

Experimental investigation of the effects of an impinging stream to enhance flue gas desulfurization at moderate temperatures