Abstract:To investigate the formation mechanism and evaluate the silicide effect on the microstructure and me-chanical properties of Ti-5Al-5Mo-5Cr-3 Nb-2Zr-xSi (Ti-xSi, wt%, x = 0, 0.2, 0.4, 0.6, 0.8) alloys, they are melted via vacuum arc melting and observed by scanning electron microscope (SEM) and transmission electron microscopy (TEM). The results indicate that their microstructure comprises grain boundary alpha (alpha GB), secondary alpha (alpha s), primary alpha (alpha p), and residual beta phases when the Si content is less than 0.2 wt%. With an increase in the Si content from 0.4 to 0.8 wt%, the content of the TiSi phase precipitated in alpha GB phase increases. Moreover, its size increases from 40 nm to 0.8 mu m. The diffusion of Si atoms from their high concentration in the beta to the alpha phase of the supersaturated solid solution is hindered by the phase boundary, resulting in the precipitation of silicides. The high energy at the interface and the diffusion of Si accelerate this precipitation. The elongation and fracture toughness increase at 0-0.2 wt% Si and then decrease at 0.4-0.8 wt% Si, peaking at Ti-0.2Si (7.1% and 66.4 MPamiddotm1/2, respectively). The strength is improved owing to the Si solid solution strengthening, precipitation of Ti5Si3 and TiSi phases, and strengthening effect caused by the difference in crystal plane spacing between the TiSi and the alpha GB phases. A higher silicide content leads to a gradual transformation from an intergranular ductile fracture to intergranular brittle fracture.(c) 2022 Elsevier B.V. All rights reserved.

Effect of Siliconizing Temperature on Microstructure and Phase Constitution of Mo–MoSi2 Functionally Graded Materials

Microstructure and Oxidation Behavior of Si–MoSi2 Functionally Graded Coating on Mo Substrate

The Characters of Mo-Mosi2 Functionally Graded Coating

Effect of Liquid-Phase Siliconizing Process on Silicon Diffusion Behavior in Mo Matrix

Microstructure and Phase Transformation Behavior of Mo–MoSi 2 Gradient Material

Formation and Oxidation Behavior of Mo-Si-B Composite Coatings with B-rich Interlayer Prepared by Slurry Sintering Method

Three Point Bending Behavior of Mo-MoSi2 Functionally Gradient Material

The Influence of Silicon Content on Microstructure and Hardness of Mo–Si Alloys

Phase composition and mechanical properties of in-situ synthetic Mo-Si compound composites

The effect of Si content on the structure and tribological performance of MoS2/Si coatings

Micromorphology evolution, growth mechanism, and oxidation behaviour of the silicon-rich MoSi 2 coating at 1200 °C in air

Influence Of Preparation Parameter On Microstructure Of Mo-Mosi2 Gradient Layer Section

Progress in Research on Mo-Mosi2 Functionally Gradient Material

Microstructure and Oxidation Behavior of Mo-Si-B Ternary Silicide

First principles study on the phase stability and mechanical properties of MoSi2 alloyed with Al, Mg and Ge

Formation Mechanism and Effect on the Mechanical Properties of TiSi Phase for Ti-5Al-5Mo-5Cr-3Nb-2Zr Alloyed by Silicon

The character of Mo-MoSi2 gradient material layer made by ihrigizing

Tensile Properties and Strengthening Mechanisms of Mo–Si Alloy

Effect of Si Content on the Uniaxial Tensile Behavior of Mo-Si Solid Solution Alloys

Preparation of Intermetallic Compound MoSi2 by Mechanical Alloying Method

Structure evolution and thermodynamics analysis of MoSi2 during mechanical alloying