Abstract:The ultrahigh static displacement-acceleration sensitivity of a mechanical sensing chip is essential primarily for an ultra-sensitive accelerometer. In this paper, an optimal design to implement to a single-axis MOEMS accelerometer consisting of a grating interferometry cavity and a micromachined sensing chip is presented. The micromachined sensing chip is composed of a proof mass along with its mechanical cantilever suspension and substrate. The dimensional parameters of the sensing chip, including the length, width, thickness and position of the cantilevers are evaluated and optimized both analytically and by finite-element-method (FEM) simulation to yield an unprecedented acceleration-displacement sensitivity. Compared with one of the most sensitive single-axis MOEMS accelerometers reported in the literature, the optimal mechanical design can yield a profound sensitivity improvement with an equal footprint area, specifically, 200% improvement in displacement-acceleration sensitivity with moderate resonant frequency and dynamic range. The modified design was microfabricated, packaged with the grating interferometry cavity and tested. The experimental results demonstrate that the MOEMS accelerometer with modified design can achieve the acceleration-displacement sensitivity of about 150 mu m/g and acceleration sensitivity of greater than 1500V/g, which validates the effectiveness of the optimal design.

Extrinsic Fabry-Perot Cantilever Accelerometer Based on Micro-Machined 45° Angled Fiber

Monolithic Integrated Cavity Optomechanical Accelerometer Based on Push-Pull Photonic Crystal Zipper Cavity

Micro All-Glass Fiber-Optic Accelerometers

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Micro-Machined Optical Fiber Side-Cantilevers for Acceleration Measurement

Piezoresistive Slot-Cantilever Type Accelerometer Inspired from Spider'S Slit Sensilla

MEMS-Based High-Sensitivity Fabry–Perot Acoustic Sensor with a 45° Angled Fiber

Miniature Tri-Axis Accelerometer Based on Fiber Optic Fabry-Pérot Interferometer.

A Miniature Fiber-Optic Fabry-Perot Accelerometer Fabricated by Laser Micro-Machining

Miniature on-fiber extrinsic Fabry-Perot interferometric vibration sensors based on micro-cantilever beam

A Fiber-Optic Fabry-Perot Accelerometer Based on High-Speed White Light Interferometry Demodulation

Theoretical Model and Design of Highly Sensitive Reflective Fiber Optic Fabry-Pérot Cavity Accelerometer Independent of Fiber Stiffness

Minitype Optical Fiber Cantilever Acceleration Sensor

Strain Force Sensor with Ultra-High Sensitivity Based on Fiber Inline Fabry-Perot Micro-Cavity Plugged by Cantilever Taper

A MEMS Based Fabry–Pérot Accelerometer with High Resolution

Silicon micromechanical accelerometer using an optical fiber

High-Sensitivity EFPI-Based Acoustic Sensor Using in-Fiber Collimator and Adjustable 45° Mirror

Fiber Optic Accelerometer Based on Fiber-Mirror Interference Cavity

Fiber-Optic Fabry–Perot Sensor for Simultaneous Measurement of Tilt Angle and Vibration Acceleration

The study of acceleration measurement using fiber grating

Temperature-Compensated Fiber Optic Fabry-Perot Accelerometer Based on the Feedback Control of the Fabry-Perot Cavity Length