Abstract:The 10MW high temperature gas cooled test reactor (HTR-10) has been built in Institute of Nuclear and New Energy Technology (INET) and has been operating successfully since the beginning of 2003. The core outlet temperature of HTR-10 is 700°C. To verify the technology of gas-turbine direct cycle, at first INET had a plan to increase its core outlet temperature to 750°C and use a helium gas turbine instead of the steam generator (then the reactor is called HTR-10GT). Though HTR-10 has good intrinsic safety, the design basic accidents and beyond design basic accidents of HTR10-GT must be analyzed according to China's nuclear regulations due to changed operation parameters. THERMIX code system is used to study the ATWS accident of one control rod withdrawal out of the core by a mistake. After a control rod in the side reflector was withdrawn out at a speed of 1cm/s by a mistake, a positive reactivity was inserted and the reactor power increased and the temperature of the core increased. When the neutron flux of power measuring range exceeded 123% and the core outlet temperature was greater than 800°C, the reactor should scram. It was supposed that all the control rods in the reflectors had been blocked and the reactor could not scram. Thus the accident went on and the core temperature and the system pressure increased but the reactor shutdown at last because of its natural negative temperature reactivity feedback mechanism, in spite of the failure of bypass valve. The residual heat would be removed out of the core by the cavity cooling system. During the accident sequence the maximum fuel temperature was 1283.3°C. It was a litter than 1230°C – the fuel temperature limitation of HTR-10. Now the sphere fuel used in HTR-10GT will also be used in HTR-PM and the temperature limitation will be raised to 1620°C, so the HTR-10GT is safe during the ATWS of one control rod withdrawal out of the core. The paper also compares the analysis result of HTR10-GT to those of HTR-10. The results shows that the HTR-10GT is still safe during the accident though its operating temperature is higher than HTR-10. The analysis will be helpful to HTR-PM for they have the same outlet temperature of the core.

Dynamic Response of the HTR-10 under the Control Rod Withdrawal Test Without Scram

Power Transients of the HTR-10 During Reactivity Insertion ATWS Tests

Influencing Factors of the HTR-10 Core Dynamics in Reactivity Insertion ATWS Tests

Thermal Behavior of the HTR-10 under Combined PLOFC and ATWS Condition Initiated by Unscrammed Control Rod Withdrawal

Post-Test Analysis of Helium Circulator Trip Without Scram at 3 Mw Power Level on the Htr-10

Simulation And Analysis Of Helium Circulator Trip Atws Test At Full Power On The Htr-10

Post-test simulation of the HTR-10 reactivity insertion without scram

Temperature Response of the HTR-10 during the Power Ascension Test

Simulation of the HTR-10Primary Mass Flow Variation Test

Temperature Analysis of the HTR-10 after Full Load Rejection

Benchmark Calculation for the Steady-State Temperature Distribution of the Htr-10 under Full-Power Operation

Design and Tests for the HTR-10 Control Rod System

The ATWS analysis of one control rod withdraw out of the HTR-10GT core in addition with bypass valve failure

The ATWS Analysis of One Control Rod Withdrawal out of the HTR-10GT Core

Experimental Study on the Residual Heat Removal System in HTR-10

Study on dynamic characteristics of HTR-10 at full power operation

A Comprehensive Study of the 14C Source Term in the 10 MW High-Temperature Gas-Cooled Reactor

ICONE19-43911 THE SIMULATION ON THE RUNNING-IN PHASE OF THE HTR-10

Simulation Method for Running-in Phase of HTR-10

Reactivity Accident Due to Control Rod Inadvertent Withdrawal of the 250mw High Temperature Gas-Cooled Reactor

Research and Measure of Tritium and Carbon 14 in HTR 10