Abstract:Low-cycle fatigue (LCF) behavior of nickel-based precipitation-strengthened superalloy GH4145/SQ was investigated systematically under fully reversed total strain amplitude control conditions at 538°C in laboratory air. It was shown that the alloy exhibited a pronounced initial fatigue hardening followed by continuous fatigue softening to failure at high strain amplitudes, while at low strain amplitudes the initial hardening was followed by a well-defined saturation stage. Microstructure observations using optical and transmission-electron microscopy revealed that slip band density increased with increasing total strain amplitudes and the size of the γ′precipitates tended to reduction due to repeated shearing by the dislocations with continuous cyclic straining. The above changes in microstructures during cycling were essentially responsible for the fatigue hardening–softening behavior of the alloy. Both optical and SEM micrographs indicated that at low strain amplitudes crack propagation was basically transgranular, while at high strain amplitudes crack propagation was essentially intergranular. Bilinear behavior with a change of slope at a plastic strain amplitude of about 0.2pct was observed in cyclic stress–strain (CSS), Coffin–Manson (C–M) and plastic strain energy–life plots. A change in the number of operating slip systems and the fracture modes with the strain amplitude employed was used to explain this two-slope characteristic. In both the companion specimens test (CST) and the incremental step test (IST) methods the alloy exhibited non-masing type behavior. It was suggested that, for the first approximation, the half-life plastic strain energy could be calculated directly according to the equation without reckoning in the non-masing behavior.

Effect of Dwell Condition on Fatigue Behavior of a High-Nb TiAl Alloy at 750 °C

Low cycle fatigue behavior of nickel-based superalloy GH4145/SQ at elevated temperature

Low Cycle Fatigue, Creep and Creep-Fatigue Interaction Behavior of a TiAl Alloy at High Temperatures

High Temperature Low Cycle Fatigue Properties and Failure Mechanism of a TiAl Alloy

Low Cycle Fatigue and Creep Fatigue Interaction Behavior of 9Cr-0.5Mo-1.8w-v-nb Heat-Resistant Steel at High Temperature

Influence of Strain Amplitude on Low-Cycle Fatigue Behaviors of a Fourth-Generation Ni-Based Single-Crystal Superalloy at 980 °C

HIGH TEMPERATURE CREEP AND FATIGUE BEHAVIOR AND LIFE PREDICTION METHOD OF A TiAl ALLOY

Dwell and Normal Cyclic Fatigue Behaviours of Ti60 Alloy

Fatigue Failure Analyses On A Ti-45al-8nb-0.2w-0.2b-0.1y Alloy At Different Temperatures

High Temperature Fatigue and Creep-Fatigue Behaviors in a Ni-based Superalloy: Damage Mechanisms and Life Assessment

High-temperature Fatigue Property of Ti46Al8Nb Alloy with the Fully Lamellar Microstructure

Studies of High-Temperature Fatigue Behavior and Mechanism for Nickel-Based Superalloy Inconel 625

Temperature Effect on Low-Cycle Fatigue Behavior of Nickel-Based Single Crystalline Superalloy

Fatigue cracking behavior and life assessment of TC11 titanium alloy in very high cycle regime at two working temperatures

Study on Creep-Fatigue Mechanical Behavior and Life Prediction of Ti2AlNb-Based Alloy

High Temperature Mechanical Constitutive Modeling of a High-Nb TiAl Alloy

Investigation on Fatigue Threshold Testing Methods in a Near Lamellar TiAl Alloy

Low-cycle Fatigue Behavior and Deformation Substructure of Ti-2Al-2.5Zr Alloy at 673K

Influence of time and temperature dependent processes on strain controlled low cycle fatigue behavior of alloy 617

Revealing the Creep-Fatigue Deformation Mechanism for a Directionally-Solidified Ni-based Superalloy DZ445 at 900 °C

Low Cycle Fatigue and High Cycle Fatigue of K4750 Ni-based Superalloy at 600 °C: Analysis of Fracture Behavior and Deformation Mechanism