Abstract:Tensile twinning is a main deformation mode in hexagonal close packed structure metals, so it is important to comprehensively understand twinning mechanisms which are not fully disclosed using 2D or small volume 3D characterization techniques. A large area 3D electron backscatter diffraction (EBSD) measurement and crystal plasticity modeling were carried out to investigate the tensile twinning behaviors in a magnesium (Mg) alloy. The results showed that tensile twinning activity was underestimated using conventional 2D EBSD scans. When compressed to yield point, the examined twin frequency with 2D was lower than that using 3D EBSD. The effects of Schmid factor (SF) on twinning were investigated. Almost all high Schmid factor (SF>0.35) grains were twinned. A surprising high twin frequency of 82% in middle SF (0.35>=SF>=0.15) grains was observed, which was unexpected since the middle SF grains were believed to be unfavorable for twinning. The twin frequency in low SF (SF<0.15) grains was slightly increased from 2D to 3D EBSD due to the small volume of twins. The shear stress maintained a high level and was homogeneously distributed in high SF grains, facilitating twin nucleation and growth. The shear stress was distributed heterogeneously within the middle SF grains, and twins were nucleated within areas with positive shear stress. The shear stress in low SF grains was not favorable for twinning and twins occurred in the vicinity of stress accumulation. Twinning activities in the same grain varied on different layers. It was attributed to the stress fluctuation derived from grain environment changes.

{10−12} Twinning Behavior in Magnesium Bicrystal

3D Atomic-Scale Growth Characteristics of {10–12} Twin in Magnesium

Three-dimensional study of grain scale tensile twinning activity in magnesium: A combination of microstructure characterization and mechanical modeling

Towards understanding double extension twinning behaviors in magnesium alloy during uniaxial tension deformation

Law of Atomic Motion during {10\\bar11} Twinning in Magnesium Alloys

The Mechanism of Twinning Activation and Variant Selection in Magnesium Alloys Dominated by Slip Deformation

Three-dimensional study of grain scale tensile twinning activity in Mg: A combination of microstructure characterization and mechanical modeling

In Situ Analysis of Deformation Twins Within a Magnesium Polycrystal: (II) Twin Growth

Crystal plasticity-based finite element modeling of twin transmission across grain boundaries in magnesium

Law of atomic motion during {101̄1} twinning in magnesium alloys

Law of Atomic Motion during f10 11g Twinning in Magnesium Alloys

Deformation Twinning Mechanism in Hexagonal-Close-packed Crystals

Investigation of Twin–twin Interaction in Deformed Magnesium Alloy

Analysis of {10–12} Twinning Variants’ Selection Behavior During Multi-Directional Compression in Mg–3Al–1Zn Magnesium Alloy

Deformation Twinning in Single-Crystal Mg under High Strain Rate Tensile Loading: A Time-Resolved X-ray Diffraction Study

Abnormal Twinning Behavior Induced by Local Stress in Magnesium

Role of Misorientation Angle in Twinning and Dislocation Slip for Nano Mg Bicrystals with [2-1-10] Symmetric Tilt Grain Boundaries under Uniaxial Compression and Tension

Quantitative investigation on the {10–12} twinning-detwinning behavior and twinning transfer of an extruded Mg-2.8Y sheet during compression-tension loading via quasi-in-situ EBSD observation

In-situ Analysis of Grain Rotation and Lattice Strain Within a Magnesium Polycrystal Based on Synchrotron Polychromatic X-ray Diffraction Technique: (I) Prior to Twin.

Experimental and Numerical Investigation of Anisotropic and Twinning Behavior in Mg Alloy under Uniaxial Tension

The Effect of Tension Twin on the Dynamic Recrystallization Behavior in Polycrystal Magnesium by Atomistic Simulation