Abstract:In order to improve the overall efficiency of machining and the defect quality of large aperture fused silica optics, it’s necessary to strictly control the crack defects and their depth uniformity in the first grinding process. Firstly, the morphology of three typical defects affecting the uniformity of crack depth was analyzed, which were scattered superficial sand holes, continuous linear defects and dotted linear defects. Then according to the morphology, the causes were investigated and the control techniques were proposed. The scattered superficial sand holes were caused by the large size glass powder, the diamond particles dropped from the grinding wheel and other foreign body impurities in the grinding fluid, which had been squeezed into the surface of the element by the grinding wheel. Through the clean filtration of grinding fluid, the quantity of such defects could be effectively reduced. The continuous linear defects were caused by stress concentration at the two sharp edges of the grinding wheel. Arcing the two sides of wheel could reduce the machining stress at the edges and avoid the occurrence of continuous linear defects. The dotted linear defects were caused by the stress concentration of the grooves on the surface of the wheel during grinding. After optimizing the dressing parameters to reduce the dressing force and avoid the grains of dressing wheel being embedded into the grinding wheel surface, all the grooves on the wheel surface and all the dashed line defects on the element surface disappeared practically. At the last, after integrating all the above control techniques, the grinding experiment of large scale fused silica optics was carried out. The scattered superficial sand holes, continuous linear defects and dotted linear defects on the surface of element after grinding were obviously alleviated. The crack depth of the whole aperture was between 4μm and 7μm. All the results indicated that the control techniques were efficacious.

Controlled Material Removal Mode and Depth of Micro Cracks in Precision Grinding of Fused Silica – A Theoretical Model and Experimental Verification

Prediction and Verification Analysis of Grinding Force in the Single Grain Grinding Process of Fused Silica Glass

Study on the Model of Surface Crack Depth in Ceramics Grinding

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Effect of grinding damage on cutting force and ductile machining during single grain scratching of monocrystalline silicon

Models of grinding-induced surface and subsurface damages in fused silica considering strain rate and micro shape/geometry of abrasive

A material point method based investigation on crack classification and transformation induced by grit geometry during scratching silicon carbide

Study of Prefabricated Crack Propagation on Monocrystalline Silicon Surfaces for Grinding Damage Analysis

Theoretical Model and Digital Extraction of Subsurface Damage in Ground Fused Silica

An Analytical Model to Predict the Depth of Sub-Surface Damage for Grinding of Brittle Materials

Effect of Grinding Parameters on Surface Roughness and Subsurface Damage and Their Evaluation in Fused Silica.

Crack Depth Uniformity Control Techniques for Large Scale Fused Silica Optics in Grinding Process

Towards understanding the crack suppression mechanism in brittle materials with high grinding speed at different temperatures

Characterization Methods of Subsurface Cracks in Grinding of Optical Elements

An analytical force and energy model for ductile-brittle transition in ultra-precision grinding of brittle materials

Surface Micro-Morphology Model Involved in Grinding of GaN Crystals Driven by Strain-Rate and Abrasive Coupling Effects

Theoretical modeling and experimental analysis of single-grain scratching mechanism of fused quartz glass

The Influence of Crystal Orientation on Subsurface Damage of Mono-Crystalline Silicon by Bound-Abrasive Grinding

Material removal mechanism and grinding force modelling of ultrasonic vibration assisted grinding for SiC ceramics

Sensitivity Analysis of the Surface Integrity of Monocrystalline Silicon to Grinding Speed with Same Grain Depth-of-cut

Modeling of the Removal Mechanism of Monocrystalline Silicon-Based on Phase Change-Dislocation Theory and Its Edge Chipping Damage During Micro-Grinding