Abstract:Thin-walled structures are now widely used in aerospace structural components, turbines and many other applications, while the control of machining distortion has become one of the most difficult problems influencing their machining quality. Machining distortion is the result of many factors, among which the machining induced residual stress is an important issue. In this paper, a finite element analysis (FEA) approach of predicting machining induced residual stresses and the consequent distortion is presented, which includes the simulation of machining process, processing of the extracted residual stress data, loading of the fitted stress data and distortion analysis. Professional metal cutting simulation and optimization software, TWS AdvantEdge, was used for 3D machining process simulation. The constitutive model of work piece material was obtained from pressure bar tests and orthogonal cutting tests, and has been proved of good accuracy. General FEM software ABAQUS was used to create and mesh the thin-plate work piece. The meshing data outputted from ABAQUS and stress data calculated by AdvantEdge were processed with MATLAB, obtaining the stress distribution of each element, and then the stress distribution was input back into ABAQUS to calculate the distortion. Experiments were carried out, measuring the residual stress and distortion, to verify the FEM simulation. Under the designed simulation and experiment conditions, the machining induced residual stresses in feeding and peripheral directions are both tensile at the machined surface and fall off to a maximum compressive state with the increase in depth, after which the compressive stresses decrease and approach a steady value next to zero in near work piece substrate. Both experimental and FEA simulation results show that the release of the residual stresses make the thin plate to become convex. Yet there are still differences in conditions between simulation and experiment, and further will be carried out- to improve the accuracy.

Distortion Prediction of a Dual-disc Part by Turning-induced Residual Stresses Mapping

Machining Distortion Prediction of Aerospace Monolithic Components

Modeling of Machining Distortion for Thin-Walled Components Based on the Internal Stress Field Evolution

Finite Element Model of Milling Process Sequence for Frame Monolithic Components

Finite Element Method Simulation for Residual Stress in Quenched Aluminum Alloy Thick-Plate and Its Effect on Machining Distortion

Finite element analysis of residual stresses and thin plate distortion after face milling

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Study on Milling Deformation of Aerospace Frame Monolithic Components

Local-global Method to Predict Distortion of Aircraft Panel Caused in Automated Riveting Process

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Study on the Machining Distortion of Thin-walled Part Caused by Redistribution of Residual Stress

Study on key technologies of straightening large-scale integrated part's distortion due to machining

Influence of uncertain parameters on machining distortion of thin-walled parts

A general model for prediction of deformation from initial residual stress

Recent Advances in the Prediction of Weld Residual Stress and Distortion - Part 1

Predicting part distortion field in additive manufacturing: a data-driven framework

A Data-Driven Method for Predicting Deformation of Machined Parts Using Sparse Monitored Deformation Data

Surface Topography Prediction Model in Milling of Thin-Walled Parts Considering Machining Deformation

Prediction of Distortion in Quenching-Tempering Processes for a SM256 Steel Component with Internal Thread

Study of distortion on milled thin-wall aluminum parts influenced by initial residual stress and toolpath strategy

Prediction Model for the Evolution of Residual Stresses and Machining Deformation of Uneven Milling Plate Blanks