3D Tungsten Disulfide/Carbon Nanotube Networks as Separator Coatings and Cathode Additives for Stable and Fast Lithium–Sulfur Batteries
Jiaqin Liu,Kaihui Li,Qi Zhang,Xiaofei Zhang,Xin Liang,Jian Yan,Hark Hoe Tan,Yan Yu,Yucheng Wu
DOI: https://doi.org/10.1021/acsami.1c13193
2021-09-16
Abstract:Commercial application of Li–S batteries is greatly restricted by their unsatisfactory cycle retention and poor cycling life originating from the lithium polysulfide (LiPS) shuttling effect and sluggish sulfur redox kinetics. Various strategies have been proposed to boost the performances of Li–S batteries, including nanostructured sulfur composites, functional separators/interlayers, electrode/electrolyte additives, and so on. However, how to combine two or more strategies to efficiently settle these challenging issues confronted by Li–S batteries is in desperate need. Here, we demonstrate a powerful combined strategy of introducing novel 3D WS2/carbon nanotube (CNT) networks built by hybridization of 1D CNTs with 2D WS2 into Li–S batteries, simultaneously serving as a functional cathode additive and separator coating. Such 3D WS2/CNTs networks with abundant edge sites, a large active surface, and a fast electron pathway twice perform functions from the cathode side and separator surface: (1) to suppress polysulfide diffusion through a physical barrier and chemical interactions; (2) to accelerate LiPS conversion reactions; and (3) to enhance conductivity for better sulfur reactivation and high utilization. As a result, the as-built WS2/CNTs-incorporated battery configuration achieves a commendable combination of capacity, rate, and cycle stability (1491 mA h g–1 at 0.2 C, 754 mA h g–1 at 5 C, and initial capacity of 1069 mA h g–1 with an ultralow decay rate of 0.040% per cycle over 1000 cycles at 1 C) along with remarkably mitigated anode corrosion and low self-discharge.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c13193.TG plot for the Super-P/sulfur composite, SEM images of CNTs, XPS survey spectra of WS2/CNTs before and after Li2S6 adsorption, optimized WS2 (001) surface model and Li2S6 molecular structure, SEM images of PP and WS2/CNTs separators and digital images of the WS2/CNTs separator under bending/folding and after cycling, SEM image coupled with EDX mappings and TEM image of WS2/CNTs after cycling, polysulfide penetration test of PP, CNT, and WS2/CNTs separators, equivalent circuit models and EIS simulation results, CV and GCD profiles of four different battery configurations, and GCD profiles of the battery using WS2/CNTs as a cathode additive and separator coating at different scan rates, and electrochemical performance comparison of Li–S batteries based on different functional separators or cathode additives (PDF)This article has not yet been cited by other publications.
materials science, multidisciplinary,nanoscience & nanotechnology