Abstract:Microstructure evolution and fracture behavior of Mg-9.5Gd-0.9Zn-0.5Zr alloy subjected to different heat treatments were systematically investigated using SEM and TEM as well as tensile testing. It was found that the microstructure of the as-cast alloy consisted of α-Mg matrix, net-like eutectic compounds (α-Mg + Mg3 (Gd, Zn)), cubic GdH2 phases and lamellar 14H LPSO phases. After solution treated at 515 °C for 24 h, two different cooling processes were used to elucidate the effect of cooling rates on the precipitation microstructure. With a hot water quenching, those secondary phases were completely dissolved. Instead, grey-like patches were observed within the α-Mg matrix, which were proposed to be rod-like Zn2Zr3 phases around the α-Zr particle. In contrast, with a furnace cooling, the formation of 14H LPSO and several cubic Mg3 (Gd, Zn) phases was observed. Furthermore, after hot water quenching, the subsequent ageing treatment parameters were also optimized to be 225 °C for 48 h. In the peak-aged condition, a denser and uniform distribution of basal precipitates γ″ and several basal precipitates γ′ together with Zn2Zr3 and ZnZr2 phases were observed. The samples after the solution treatment (for both hot water quenching and furnace cooling) showed a much higher ductility than the as-cast alloy, while the tensile yield strength (TYS) and ultimate tensile strength (UTS) remained unchanged. After the peak-ageing, a significant increase in the TYS and UTS but a great loss in ductility was observed. In the as-cast alloy, the initiation of microcracks occurred from the net-like eutectic compounds, which was believed to be one of the most important reasons for the tensile fracture, and showed a co-existence of intergranular and transgranular fracture behavior. After the solution treatment, with a hot water quenching, the fracture can be mainly related with failures along contraction twins, and then showed a transgranular fracture behavior. While, with a furnace cooling, due to the presence of the kinked 14H LPSO phases, the fracture was caused by the broken of 14H LPSO phases, and then lead to a transgranular fracture. The peak-aged alloy exhibited a brittle intergranular fracture, which can be related with failures along soft precipitation free zones (PFZs).

Tensile Crack Initiation Behavior of Cast Mg–3Nd–0.2Zn–0.5Zr Magnesium Alloy

The Microstructure and Mechanical Properties of As-cast Mg-10Gd-3Y-xZn-0.6Zr (x=0, 0.5, 1 and 2 Wt%) Alloys

Effects of Grain Size and Heat Treatment on the Tensile Properties of Mg–3Nd–0.2Zn (wt%) Magnesium Alloys

Strain-controlled cyclic deformation behavior of cast Mg–2.99Nd–0.18Zn–0.38Zr and AZ91D magnesium alloys

Microstructure evolution and fracture behavior of Mg-9.5Gd-0.9Zn-0.5Zr alloy subjected to different heat treatments

Investigations on Microstructure and Mechanical Properties of Cast Mg-Gd-Y-Zn-Zr-Nd Alloy

Effects of Heat Treatments on the Microstructures and Mechanical Properties of Mg–3Nd–0.2Zn–0.4Zr (wt.%) Alloy

High Cycle Fatigue of Cast Mg-3Nd-0.2Zn Magnesium Alloys

Study on high cycle fatigue behavior of gravity cast Mg-3Nd-0.2Zn-Zr magnesium alloy

The Effect of Microstructure on the Plastic Strain Localization and Fatigue Crack Initiation in Cast Mg–8Gd–3Y–0.5Zr Alloy

Microstructure and mechanical properties of Mg–4Al–4Nd–0.5Zn–0.3Mn alloy

Effect of heat treatment on strain–controlled fatigue behavior of cast Mg–Nd–Zn–Zr alloy

The Tensile Properties and Fracture Toughness of a Cast Mg-9Gd-4Y-0.5Zr Alloy

Damage Morphology Study of High Cycle Fatigued As-Cast Mg–3.0Nd–0.2Zn–Zr (wt.%) Alloy

Failure Behavior of High Pressure Die Casting AZ91D Magnesium Alloy

High cycle fatigue behaviors of low pressure cast Mg–3Nd–0.2Zn–2Zr alloys

Microstructural Characteristics and Mechanical Properties of Cast Mg–3Nd–3Gd–xZn–0.5Zr Alloys

Microstructure and Mechanical Properties of As-Cast and Solution-Treated Mg-Zn-Gd-based Alloys Reinforced with Quasicrystals

Comparison on crack propagation under tension at 150 °C of Mg-2Zn-1.5Mn alloy sheets with and without crack notch

A Comparison of Low-Cycle Fatigue Behavior Between the Solutionized and Aged Mg-3Nd-0.2Zn-0.5Zr Alloys

In-Situ Study of the Tensile Deformation and Fracture Modes in Peak-Aged Cast Mg-11Y-5Gd-2Zn-0.5Zr (weight Percent)