Abstract:Fractures in natural rocks have an important effect on the strength and failure behavior of rock mass, which are often evaluated in rock engineering practice. The theoretical evaluation of mechanical behavior of fractured rock mass has no satisfactory answer due to the role of confining pressure and crack geometry. Therefore, in this paper, conventional triaxial compression experiments were carried out to study the strength and failure behavior of marble samples with two pre-existing closed cracks in non-overlapping geometry. Based on the experimental results of a number of triaxial compression tests, the effect of crack coalescence on the axial supporting capacity and deformation property were investigated with different confining pressures. The results show that intact samples and flawed samples (marble with pre-existing cracks) have different deformation properties after peak stress, which change from brittleness to plasticity and ductility with the increase of confining pressure. The peak strength and failure mode are found depending not only on the geometry of flaw, but also on the confining pressure. The strength of flawed samples shows distinct non-linear behavior, which is in a better agreement with non-linear Hoek–Brown criterion than linear Mohr–Coulomb criterion. For a kind of rock that has been evaluated as a Hoek–Brown material, a new evaluation criterion is put forward by adopting optimal approximation polynomial theory, which can be used to confirm more precisely the strength parameters (cohesion and internal friction angle) of flawed samples. For intact samples, the marble leads to typical shear failure mode with a single fracture surface under different confining pressures, while for flawed samples, under uniaxial compression and a lower confining pressure (σ3=10MPa), tests for coarse and medium marble (the coarse and medium refer to the grain size) exhibit three basic failure modes, i.e., tensile mode, shear mode, and mixed mode (tensile and shear). Shear mode is associated with lower strength behavior. However, under higher confining pressures (σ3=30MPa), for coarse marble, the axial supporting capacity is not related to the geometry of flaw. The friction among crystal grains determines the strength behavior of coarse marble. For medium marble, the failure mode and deformation behavior are dependent on the crack coalescence in the sample. The present research provides increased understanding of the fundamental nature of rock failure under conventional triaxial compression.

A Micro–macro Method for Predicting the Shear Strength of Brittle Rock under Compressive Loading

Estimation of Micromechanical Strength of Brittle Rocks under Compression

Preliminary Study of Two-Scale Model for Analyzing Brittle Rock Based on Asymptotic Expansion Method

A Micro–macro Model of Pore Pressure Effect on Shear Fracture in Brittle Rocks under Compression

Effects of Crack Inclination on Shear Failure of Brittle Geomaterials under Compression

Micromechanics-based model study of shear properties of brittle rocks

A Micromechanical Method to Predict Macroscopic Behavior of Brittle Creep Failure in Rock

A Micro–macro Method for Evaluating Progressive and Direct Tensile Fractures in Brittle Rocks

Microcrack Statistics, Weibull Distribution and Micromechanical Modeling of Compressive Failure in Rock

Evaluation of Strength and Failure of Brittle Rock Containing Initial Cracks under Lithospheric Conditions

A Micro-Macro Dynamic Compressive-Shear Fracture Model under Static Confining Pressure in Brittle Rocks

Experimental Investigation on Strength and Failure Behavior of Pre-cracked Marble under Conventional Triaxial Compression

Investigation of Macroscopic Brittle Creep Failure Caused by Microcrack Growth Under Step Loading and Unloading in Rocks

Evolution Mechanism and Quantitative Characterization of Initial Micro-Cracks in Marble under Triaxial Compression

A Study on the Creeping Failure Related to Crack Inclination of Brittle Rocks

Study on rock crack damage and confining pressure effects on shear fracture band

Study on Microcrack Growth-Based Dynamic Compressive Mechanical Properties in Brittle Rocks

A Microcrack Growth-Based Constitutive Model for Evaluating Transient Shear Properties During Brittle Creep of Rocks

Investigation of microcracking behaviors in brittle rock using polygonal grain‐based distinct method

Research on crack initiation mechanism and fracture criterion of rock-type materials under compression–shear stress

Macro-micro mechanical modelfor progressive and creep failure of brittle rock