Abstract:Based on the HVDC power transmission project from Tianshengqiao to Guangzhou the mechanism leading to converter valve overvotage is analyzed and analysis results show that overvoltage will appear at both terminals of the valves under two conditions： the first one is that after turning-off all valves in uppermost layer of commutating group overvoltages appear at both terminals of the valves belonging to this layer, whereas when all valves belonging to other layers of commutating groups are turned-off there in general will not be overvotlages appearing at both terminals of these valves; the second one is that the switching surge due to interphase operation in AC-system will lead to higher overvoltage appearing at both terminals of valves. According to the analysis results, simulation analysis on two typical faults, namely the single-phase short-circuit occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer and switching surge caused by interphase operation in AC-system, is performed. Simulation results show that when HVDC system is operated in minimum power transmission mode, the single-phase short-circuit fault occurred at upper-half rectifier bridge side of wye-wye connected winding of converter transformer will lead to higher overvotage at both terminals of valves while the energy passing through valve arrester reaches its maximum value, however, along with the increase of transmitted power the energy passing through valve arrester will decrease; in view of the fact that the transformation ratio of converter transformer configured in rectifier station is higher than that in inverter station, the swithching surge caused by interphase operations in AC system, which possess the same amplitude, will lead to relatively serious overvotlage appearing at both terminals ot converter valves in rectifier station.

TECHNIQUE FEATURES OF THYRISTOR VALVE USED FOR ±500 kV HVDC TRANSMISSION FROM THE THREE GORGES TO CHANGZHOU

VSC-MTDC Transmission Technologies and Its Application in Zhoushan

Research on the Vertical Installation Technology in Flexible DC Valve Hall

A study on monitoring technology for multi-terminal ±500kV VSC-HVDC power transmission system

Overvoltage Mechanism of Converter Valves for HVDC Power Transmission Project from Tianshengqiao to Guangzhou

Research on Converter Valve Overvoltage Mechanism and Calculation Conditions of ± 800 Kv Converter Station

500 Kv HVDC Valve Impact Test Technology

Summary of Fault Characteristic of Thyristors in HVDC Converter Valve under Over-voltage Condition

Upgrade Study Of High Power Electronics Laboratory For +/- 800kv Uhvdc Valves

Study on Hybrid HVDC Transmission Technology Used for Upgrading of Conventional HVDC Transmission System

Study on synthetic test technology of thyristor level with TCU in the converter valve of HVDC transmission

DC switching overvoltage of ± 1100 kV UHVDC converter station

Research on Routine Test of HVDC Converter Valve and Its Engineering Practice

Cascaded H7 Current Source Converter Based Power Transmission System And Fault Analysis

Study on Operating Performance and Failures Mechanism of UHVDC Thyristor Valves

Analysis on Insulation Coordination Scheme for ±800 Kv DC Converter Station

The Development of HVDC Transmission System

A Novel Synthetic Test System for Thyristor Level in the Converter Valve of Hvdc Power Transmission

Applicable occasions of UHVAC/UHVDC transmission and their technology comparisons in China

DISCUSSION ON SEVERAL IMPORTANT PROBLEMS OF DEVELOPING UHV AC TRANSMISSON IN CHINA

Design and Implementation of Synthetic Test System for Thyristor Level of HVDC Converter Valve