Abstract:Abstract The coastal pipelines are the key link between the offshore and the onshore pipelines, which are located in the soil dry-wet alternating environment. Even though higher corrosion risk of metals in coastal soil dry-wet alternating environment, few papers focused on this condition, while much research about ocean and atmospheric dry-wet alternating environment was paid attention to. In this paper, a self-designed soil dry-wet alternating experimental device was used to investigate the corrosion characteristics of Q235 steel in seawater, soil and dry-wet alternating environment based on mass loss experiments, corrosion morphology analysis and electrochemical experiments. The results showed that the general corrosion rate of Q235 steel in soil and seawater environments basically remained unchanged, and in dry-wet alternating environment increased with time, while the pitting rates were 0.280 mm/a (soil), 0.420 mm/a (seawater) and 0.567 mm/a (dry-wet alternation), respectively, which was caused by the oxygen concentration cell and salt concentration cell. Meanwhile, the growth rate of pitting size in dry-wet alternating environment was much higher than that in the other two environments with different corrosion characteristics of pitting corrosion (seawater and dry-wet alternation) and a changed from general corrosion to pitting corrosion (soil). In three environments, the corrosion current density ( I corr ) increased, in which on the 30th day of experiment, I corr = 79.72 μ A cm −2 in dry-wet alternating environment, which was much higher than I corr = 47.89 μ A cm −2 in seawater environment. In dry-wet alternating environment, the mass diffusion impedance at 10 –2 Hz and the maximum phase angle changed significantly, while the log f -log∣ Z ∣ curve in low-middle frequency decreased significantly, and charge transfer resistance at 10 5 Hz reduced from 10.4 Ω to 4.3 Ω, illustrating an increasing corrosion rate.

Problem Exploration in Accelerating Corrosion Test of Transistors in the Marine Environment

Accelerating Tests For The Performance Deterioration Of Concrete Exposed To Chloride Media

Corrosion Development of Carbon Steel Grids and Shear Connectors in Cracked Composite Beams Exposed to Wet-Dry Cycles in Chloride Environment.

Research on accelerated corrosion of 0Cr18Ni9 stainless steel in marine atmospheric environment of the South China Sea

Development and Optimization of the Simulation Test Device for Corrosion in Marine Environment

Corrosion Behaviors of TWIP Steels in NaCl Solution

An Experimental Study on Constant Current Load Test of Reinforced Concrete based on 3D Paraffin Isolation

Correlation between Laboratory-Accelerated Corrosion and Field Exposure Test for High-Strength Stainless Steels

Technical Note: Study on Accelerated Corrosion Behavior and Mechanism of X80 Pipeline Steel Welded Joint under Cyclic Salt Spray Test

Antimicrobial Susceptibility of Bacillus anthracis in an Endemic Area

Study on corrosion characteristics of Q235 steel in seawater, soil and dry-wet alternating environments focusing on Shengli oilfield

Study on corrosion behavior of typical carbon steel and low alloy steel in deep sea of different sea areas

Corrosion behavior and cellular automata simulation of carbon steel in salt-spray environment

Multi-performance evaluation of high-throughput accelerated corrosion test for high-strength low-alloy 921A steel

Microscopic investigation on pitting corrosion of Ni-Cr-Mo-V high-strength steel weldment in simulated deep-sea environment

Comparative Study on the Corrosion Behaviours of High-Silicon Chromium Iron and Q235 Steel in a Soil Solution

A Comparative Study of the Corrosion Behavior of 30CrMnSiNi2A in Artificial Seawater and Salt Spray Environments

Long-term field exposure corrosion behavior investigation of 316L stainless steel in the deep sea environment

Corrosion behavior research and corrosion prediction of structural steel in marine engineering

Modeling of Galvanic Corrosion in three-metal Systems Consisting of ZM5 Magnesium Alloy, 6XXX Series Aluminium Alloy and 304 Stainless Steel under Thin Electrolyte Layer by Numerical Simulation, Electrochemical and Salt Spray Test

Study on corrosion, hydrogen permeation, and stress corrosion cracking behaviours of AISI 4135 steel in the tidal zone