Abstract:Mechanical properties of steels are significantly enhanced by retained austenite. Particularly, it has been shown that a recently developed heat-treatment technique called Quenching and Partitioning (Q&P) stabilises austenite effectively. In the present work, the phase-field approach is adopted to simulate the phase transformation and carbon diffusion, which respectively accompanies the quenching and partitioning process of the polycrystalline Fe-C system. By incorporating the chemical driving-force from the CALPHAD database, the elastic phase-field model, which recovers the sharp-interface solutions, simulates the martensite ( α ′ ) transformation at three different quenching temperatures. The resulting martensite volume-fractions are in complete agreement with the analytical predictions. For the first time, in this study, the constrained carbon equilibrium (CCE) condition is introduced in the polycrystalline set-up to yield the predicted partitioning endpoints. Under the CCE condition, the carbon partitioning in two alloys of varying composition is analysed through the phase-field model which employs chemical potential as the dynamic variable. The volume fraction and distribution of retained austenite is determined from the carbon distribution and its temporal evolution during the partitioning is investigated. It is identified that in the initial stages of partitioning carbon gets accumulated in the austenite ( γ ) along the γ α ′ -interface, owing to the substantial difference in the diffusivities and CCE endpoints. This accumulation stabilises the austenite adjacent to the interface. However, depending on the martensite volume-fraction and the alloy composition, the evolution of the stabilised austenite varies. Furthermore, the influence of the phase distribution on the kinetics of the temporal evolution of retained austenite is elucidated.

DECOMPOSITION OF THE Ε-Phase OBTAINED BY MEANS OF SPLAT QUENCHING IN THE Fe-C-Sb ALLOY

PHASE IN Fe-C, Fe-C-Sb ALLOY SYSTEMS OBTAINED BY SPLAT QUENCHING

Decomposition in multi-component AlCoCrCuFeNi high-entropy alloy

Thermal stability of Al–Fe–Ni alloy at high temperatures

Decomposition Kinetics of Carbon-Doped FeCoCrNiMn High-Entropy Alloy at Intermediate Temperature

Phase-field Simulation of Phase Separation Coupled with Thermodynamic Databases in FeNiCrCoCu High-Entropy Alloys

Phase-field analysis of quenching and partitioning in a polycrystalline Fe-C system under constrained-carbon equilibrium condition

Experimental and Theoretical Investigations on the Phase Stability and Mechanical Properties of Cr7Mn25Co9Ni23Cu36 High-Entropy Alloy

Studies of the Co-Existence of Spinodal Decomposition and Ordering in Fe-Al Alloy Using Internal Friction Method

Effects of Grain Boundaries and Temperature on Spinodal Decomposition in a Binary Fe-Cr Alloy: A Phase-Field Simulation

Effect Mechanism of α-Ferrite Sustained Precipitation on High-Temperature Properties in Continuous Casting for Peritectic Steel

Non-equilibrium transformation in hypercooled Fe83B17 alloy

Phase Transformations after Heat Treating an As-Cast Fe-30Mn-8.8Al-0.3Si-0.15C Steel

Liquid Phase Separation and Solidification of Cu40Co3oCr30 Alloy under Different Cooling Conditions

Phase transformation of /spl beta/-FeSi/sub 2/-based alloys under in-situ high-temperature and high-pressure X-ray diffraction measurements

Relationship between the Crystallographic Structure of Electrodeposited Fe-P Alloy Film and its Thermal Equilibrium Phase Diagram

Spinodal Decomposition of B2‐phase and Formation of Cr‐Rich Nano‐precipitates in AlCoCrFeNi2.1 Eutectic High‐Entropy Alloy

Distinct Oxidation Behaviour Attributed to Phase Constitution Transformation at Different Hot Processing Temperatures in Fe-10Mn-5.5Al-0.25C Steel

Phases Formation and Evolution at Elevated Temperatures of Al–12Si–3.8Cu–2Ni–1Mg Alloy†

Phase transformation and microstructure evolution of pearlite heat-resistant steel during heating

Phase transformation of FeC2O4 · 2H2O heat treated in H2NH3