Abstract:As a new nondestructive testing technology, ultrasonic guided wave technology has the advantages of long detection distance, fast speed, low cost, and can detect places that can not be detected by general conventional detectors, such as special pipelines such as casing or buried pipelines. Pressure pipeline is an important special equipment. It is often necessary to carry out radiographic inspection of welded joints in regular inspection, but it is difficult to implement in some practical occasions. This paper studies the ultrasonic imaging testing of typical welding defects, and compares the ultrasonic imaging testing results with the radiographic testing results. The results show that ultrasonic imaging testing can not only detect all welding defects, but also has more advantages than radiographic testing in defect location and defect quantification. When radiographic testing is difficult to implement, ultrasonic imaging testing can be used as a supplement to radiographic testing. On the basis of understanding the research status and development trend of related technologies at home and abroad, and clarifying the principle and requirements of phased array ultrasonic imaging detection of steel pipes, the research on key technologies such as phased array ultrasonic imaging based on mechanical and electronic composite scanning and online phased array ultrasonic imaging detection of steel pipe near-end defects was focused on, which solved the problems of image splicing and blind spots of end defect detection in multi-scanning mode. At the same time, combining phased array ultrasonic nondestructive testing with mechatronics technology, a set of online quantitative nondestructive testing system for steel pipes based on phased array ultrasonic imaging was developed, and related experimental research was carried out to verify the feasibility and effectiveness of the proposed technology.

Application of Ultrasonic Guided Waves in Pipe′s NDT

Evaluation of Pipe Axial Defeat Through the Use of Ultrasonic Guided Wave and Matching Pursuit

Implementing Ultrasonic Guided Wave Mode Control in Hollow Cylinders

Nonuniform Temperature Compensation in Ultrasonic Guided Wave Pipeline Health Monitoring Using Local Phase Matching

Ultrasonic Guided Wave Approach Incorporating SAFE for Detecting Wire Breakage in Bridge Cable

Application Research of Ultrasonic-Guided Wave Technology in Pipeline Corrosion Defect Detection: A Review

Ultrasonic Guided Wave Testing Trials for Pipes

Ultrasonic guided wave techniques and applications in pipeline defect detection: A review

Research on the Integrated Ultrasound and Eddy Automatic Inspection System of Seamless Steel Pipe

Non-destructive Evaluation of Spiral-welded Pipes Using Flexural Guided Waves

Optimal parameters of ultrasonic guided waves non-destructive testing in viscous liquid-filled elastic pipes

Development of the Ultrasonic Guided Wave Detecting System for Pipeline Based on the Magnetostrictive Effect

Imaging of Nonaxisymmetric Area Discontinuities in Pipes Using Guided Wave Synthetic Focusing

Ultrasonic Imaging Detection of Welding Joint Defects of Pressure Pipeline Based on Phased Array Technology

Application of Microwaves for Nondestructive and High-Efficiency Detection of Wall Thinning Locations in a Long-Distance Metal Pipe

A high-efficiency nondestructive method for remote detection and quantitative evaluation of pipe wall thinning using microwaves

Deconvolution Imaging of Weak Reflective Pipe Defects Using Guided-Wave Signals Captured by a Scanning Receiver

Evaluation of Notches in Pipes through the Use of Guided Wave and the Reflection Coefficient Method

Detection, Localisation and Assessment of Defects in Pipes Using Guided Wave Techniques: A Review

Excitation Frequency Choice and Sensitivity Analysis in the Inspection of Pipe with Ultrasonic Guided Waves

Excitation of Axisymmetric and Non-Axisymmetric Guided Waves in Elastic Hollow Cylinders by Magnetostrictive Transducers