Abstract:Under the trend of vehicle intelligentization, many electrical control functions and control methods have been proposed to improve vehicle comfort and safety, among which the Adaptive Cruise Control (ACC) system is a typical example. However, the tracking performance, comfort and control robustness of the ACC system need more attention under uncertain environments and changing motion states. Therefore, this paper proposes a hierarchical control strategy, including a dynamic normal wheel load observer, a Fuzzy Model Predictive Controller and an integral-separate PID executive layer controller. Firstly, a deep learning-based dynamic normal wheel load observer is added to the perception layer of the conventional ACC system and the observer output is used as a prerequisite for brake torque allocation. Secondly, a Fuzzy Model Predictive Control (fuzzy-MPC) method is adopted in the ACC system controller design, which establishes performance indicators, including tracking performance and comfort, as objective functions, dynamically adjusts their weights and determines constraint conditions based on safety indicators to adapt to continuously changing driving scenarios. Finally, the executive controller adopts the integral-separate PID method to follow the vehicle's longitudinal motion commands, thus improving the system's response speed and execution accuracy. A rule-based ABS control method was also developed to further improve the driving safety of vehicles under different road conditions. The proposed strategy has been simulated and validated in different typical driving scenarios and the results show that the proposed method provides better tracking accuracy and stability than traditional techniques.

Cooperative Control of Clutch and Hydraulic Control Unit

Robust Output Feedback Controller with High-Gain Observer for Automatic Clutch

Multi-objective H2/H∞ control of uncertain active suspension systems with interval time-varying delay

Adaptive Prescribed Performance Control of Half-Car Active Suspension System with Unknown Dead-Zone Input

Shared control for human–machine co-driving vehicles based on constraint-following approach

Robust LMI-Based H-Infinite Controller Integrating AFS and DYC of Autonomous Vehicles with Parametric Uncertainties

Hierarchical Control of Starting Process for Wet Dual Clutch Transmission Based on Direct-Drive Pump-Controlled Hydraulic Actuator

Finite-Time Adaptive Control for Electro-Hydraulic Braking Gear Transmission Mechanism with Unilateral Dead Zone Nonlinearity

Adaptive longitudinal control for multivehicle cooperative systems with actuator saturation under road bumps

Lateral Stability Control for Intelligent Commercial Vehicle Based on Reconstructed Objective Function Method

Modular Integrated Longitudinal, Lateral, and Vertical Vehicle Stability Control for Distributed Electric Vehicles

Hierarchical control for a full hybrid vehicle with single motor and double clutches

Disturbance Observer Based Compound Control for an Air-Breathing Hypersonic Vehicle

Nonlinear robust control of integrated vehicle dynamics

Multi-Objective Collaborative Control Method for Multi-Axle Distributed Vehicle Assisted Driving

A top-down integration approach to vehicle stability control

Simultaneous Estimation and Receding Horizon Sliding Control of Dog Clutch Coupling with Backlash for Rear Electrical Drivelines

Position-based impedance torque control for automatic clutch with robust predefined-time stability guarantee

Cooperative Control for Air-Ground Systems via Bidirectional Signal Connection in Complex Environment

Adaptive Cruise System Based on Fuzzy MPC and Machine Learning State Observer

Integrated longitudinal and lateral control for autonomous vehicles with active load transfer strategy at the handling limits