Abstract:Wireless Power Transfer (WPT) and wireless data communication are both important problems of research with various applications, especially in medicine. However, these two problems are usually studied separately. In this work, we present a joint study of both problems. Most medical electronic devices, such as smart implants, must have both a power supply to allow continuous operation and a communication link to pass information. Traditionally, separate wireless channels for power transfer and communication are utilized, which complicate the system structure, increase power consumption and make device miniaturization difficult. A more effective approach is to use a single wireless link with both functions of delivering power and passing information. We present a design of such a wireless link in which power and data travel in opposite directions. In order to aggressively miniaturize the implant and reduce power consumption, we eliminate the traditional multi-bit Analog-to-Digital Converter (ADC), digital memory and data transmission circuits all together. Instead, we use a pulse stream, which is obtained from the original biological signal, by a sigma-delta converter and an edge detector, to alter the load properties of the WPT channel. The resulting WPT signal is synchronized with the load changes therefore requiring no memory elements to record inter-pulse intervals. We take advantage of the high sensitivity of the resonant WPT to the load change, and the system dynamic response is used to transfer each pulse. The transient time of the WPT system is analyzed using the coupling mode theory (CMT). Our experimental results show that the memoryless approach works well for both power delivery and data transmission, providing a new wireless platform for the design of future miniaturized medical implants.

A Simultaneous Power and Downlink Data Transfer System with Pulse Phase Modulation.

Study of Data and Power Transmission Based on Frequency-Shift Modulation in Wireless Charging

A Simultaneous Wireless Power and Uplink Data Transfer System with Ultra-Low Crosstalk Between the Power and Data Link.

A New Simultaneous Wireless Power and Information Transfer System with Integrated Signal Magnetic Coupler.

Simultaneous High-Efficiency Power Delivery and Energy-Efficient Forward Data Transmission over Single Inductive Link

Analysis and Design of a Simultaneous Wireless Power and Data Transfer System Featuring High Data Rate and Signal-to-Noise Ratio

A Novel Simultaneous Wireless Power and Data Transfer Scheme for Two-stage Inductive Power Transfer Systems

Simultaneous Wireless Power and Data Transfer System With Single Coil Based on Multifrequency Modulation

A shared-link type wireless power and data simultaneous transfer system based on a series–parallel resonant network

Simultaneous Wireless Power Transfer and Data Communication Using Synchronous Pulse-Controlled Load Modulation

A FDM-based Simultaneous Wireless Power and Data Transfer (SWPDT) System Functioning with High-rate Full-duplex Communication

A Novel Modulation and Demodulation Method for Wireless Power and Data Transmission

An FDM-Based Simultaneous Wireless Power and Data Transfer System Functioning with High-Rate Full-Duplex Communication.

Simultaneous Wireless Power and Data Transfer System with Full-Duplex Mode Based on Dual-Resonant Frequencies and Resistance-Based Duplexer

Wireless Power and Data Transfer Via a Common Inductive Link Using Frequency Division Multiplexing

Simultaneous Wireless Power and Data Transfer: A Comprehensive Review

Parameter Design Method For Wireless Power And Data Transmission Via The Same Inductive Link

DiTTO: A Distance Adaptive Over 100-mW Wireless Power Transfer System With 1.695-Mb/s Uplink Telemetry and a Shared Inductor Two-Output Regulating Rectification

A Bidirectional Simultaneous Wireless Power and Data Transfer System with Non-Contact Slip Ring

Simultaneous Wireless Power and High-Rate Full-Duplex Data Transfer System Based on 4ASK

A 70%-power transmission efficiency, 3.39 Mbps power and data telemetry over a single 13.56 MHz inductive link for biomedical implants