Abstract:Wireless Power Transfer (WPT) and wireless data communication are both important problems of research with various applications, especially in medicine. However, these two problems are usually studied separately. In this work, we present a joint study of both problems. Most medical electronic devices, such as smart implants, must have both a power supply to allow continuous operation and a communication link to pass information. Traditionally, separate wireless channels for power transfer and communication are utilized, which complicate the system structure, increase power consumption and make device miniaturization difficult. A more effective approach is to use a single wireless link with both functions of delivering power and passing information. We present a design of such a wireless link in which power and data travel in opposite directions. In order to aggressively miniaturize the implant and reduce power consumption, we eliminate the traditional multi-bit Analog-to-Digital Converter (ADC), digital memory and data transmission circuits all together. Instead, we use a pulse stream, which is obtained from the original biological signal, by a sigma-delta converter and an edge detector, to alter the load properties of the WPT channel. The resulting WPT signal is synchronized with the load changes therefore requiring no memory elements to record inter-pulse intervals. We take advantage of the high sensitivity of the resonant WPT to the load change, and the system dynamic response is used to transfer each pulse. The transient time of the WPT system is analyzed using the coupling mode theory (CMT). Our experimental results show that the memoryless approach works well for both power delivery and data transmission, providing a new wireless platform for the design of future miniaturized medical implants.

DiTTO: A Distance Adaptive Over 100-mW Wireless Power Transfer System With 1.695-Mb/s Uplink Telemetry and a Shared Inductor Two-Output Regulating Rectification

A New Simultaneous Wireless Power and Information Transfer System with Integrated Signal Magnetic Coupler.

Simultaneous High-Efficiency Power Delivery and Energy-Efficient Forward Data Transmission over Single Inductive Link

A Novel Simultaneous Wireless Power and Data Transfer Scheme for Two-stage Inductive Power Transfer Systems

Analysis and Design of a Simultaneous Wireless Power and Data Transfer System Featuring High Data Rate and Signal-to-Noise Ratio

A Dual-Frequency Three-Dimensional WPT System with Directional Power Transfer Capability at Two Separately Regulated Outputs

High-Efficiency Omnidirectional Wireless Power Transfer System

Simultaneous Wireless Power Transfer and Data Communication Using Synchronous Pulse-Controlled Load Modulation

Simultaneous Wireless Power and Data Transfer System with Full-Duplex Mode Based on Dual-Resonant Frequencies and Resistance-Based Duplexer

A 6.78-Mhz Coupling Coefficient Sensorless Wireless Power Transfer System Charging Multiple Receivers with Efficiency Maximization by Adaptive Magnetic Field Distributor IC

High-Efficiency Multi-User Wireless Power Transfer by Sequentially Tracking the Optimal Rectified Power of Multiple Groups with a Power-Limited Transmitter

Wireless Power and Data Transfer Via a Common Inductive Link Using Frequency Division Multiplexing

A shared-link type wireless power and data simultaneous transfer system based on a series–parallel resonant network

Single-stage Dual-Output AC-DC Converter for Wireless Power Transmission.

Output-voltage Adaptive of Omnidirectional Wireless Power Transfer Based on Receivers with Digital Coils

A Simultaneous Power and Downlink Data Transfer System with Pulse Phase Modulation.

A High-Misalignment-Tolerant and Extensive Vertical Adaptation Combined Simultaneous Transmission of Power and Data for WPT System

Highly Efficient Wideband mmWave Rectennas for Wireless Power Transfer System with Low-Cost Multi-Node Tracking Capability

A Simultaneous Wireless Power and Uplink Data Transfer System with Ultra-Low Crosstalk Between the Power and Data Link.

A FDM-based Simultaneous Wireless Power and Data Transfer (SWPDT) System Functioning with High-rate Full-duplex Communication

Analysis and Design of Wireless Power and Data Synchronous Transfer System Based on 2FSK Modulation Using Dual-Resonant Frequency