Simultaneous Wireless Power and Data Transfer System With Single Coil Based on Multifrequency Modulation

Zhen Yang,Chun Gan,Haochen Shi,Yu Chen,Kai Ni,Ronghai Qu
DOI: https://doi.org/10.1109/tie.2023.3294609
IF: 7.7
2023-01-01
IEEE Transactions on Industrial Electronics
Abstract:The existing energy modulation simultaneous wireless power and data transfer (EM-SWPDT) system will cause severe load voltage drop and power efficiency reduction at the data transmitting. Besides, those methods can only achieve simplex communication. To solve these problems, this article proposes a single coil half-duplex communication EM-SWPDT system using a novel multifrequency modulation, which can enhance data transmission performance. By modulating the conduction angle of the converter with desired signal frequency, the steady state and sinusoidal fluctuating states are realized, which compose different data wave, respectively. Because the data transmission relies on frequency information instead of amplitude information, the load voltage drop can be reduced. And the phase-shifting equivalent current model is constructed to evaluate the influence of data transmission on load voltage. Since the data modulation is performed by the converters of wireless power transfer system, additional auxiliary data circuits, such as signal generators and wave trappers are omitted and branch crosstalk is reduced. Therefore, the influence of data transmission on power transmission efficiency is weak. Finally, the effectiveness of the proposed EM-SWPDT system with a novel multifrequency modulation is verified by experimental platforms.
automation & control systems,engineering, electrical & electronic,instruments & instrumentation
What problem does this paper attempt to address?
### Problems the paper attempts to solve This paper aims to solve several key problems existing in the existing energy - modulated simultaneous wireless power and data transfer (EM - SWPDT) systems during the data transfer process: 1. **Severe load voltage drop**: The existing EM - SWPDT systems will cause a significant drop in load voltage during data transfer, affecting the stability and performance of the system. 2. **Reduced power efficiency**: During the data transfer process, the power transfer efficiency of the system will be significantly reduced. 3. **Only simplex communication can be achieved**: The existing methods can only achieve one - way communication and cannot achieve half - duplex or full - duplex communication. To overcome these problems, the paper proposes a single - coil half - duplex communication EM - SWPDT system based on multi - frequency modulation. This system realizes the steady - state and sinusoidal fluctuation states by modulating the conduction angle of the converter, thereby transmitting different data waveforms. Since data transfer depends on frequency information rather than amplitude information, the drop in load voltage can be reduced. In addition, the paper also constructs a phase - shift equivalent current model to evaluate the impact of data transfer on load voltage. ### Main contributions 1. **Multi - frequency modulation method**: By modulating the conduction angle of the converter, the switching between the steady - state and the fluctuating state is realized, thereby transmitting "0" or "1" data. 2. **Simplified system structure**: Data modulation is completed by the converter of the wireless power supply system, without the need for additional auxiliary data circuits, such as signal generators and wave capturers, reducing branch crosstalk. 3. **Improved data transfer performance**: The data transfer rate is relatively high, and the impact on power transfer efficiency is small. 4. **Experimental verification**: The effectiveness and feasibility of the proposed EM - SWPDT system are verified through an experimental platform. ### Conclusion The paper proposes a single - coil half - duplex communication EM - SWPDT system based on multi - frequency modulation, which effectively solves the problems of load voltage drop and power efficiency reduction in the existing systems during the data transfer process, and at the same time achieves a relatively high data transfer rate. This system has the characteristics of simple structure and superior performance and is suitable for a variety of practical application scenarios.