Abstract:High-energy ball milling represents an efficient process for producing composite powders consisting of ceramic particles dispersed in a metallic matrix. However, collision events, plastic deformations, and cold welding during the milling lead to a flake or block-like shape of the resulting composite powders. Further consolidation of such irregularly shaped powders by powder bed-based additive manufacturing technologies can be challenging because of their low flowability and low bulk density. In this work, different approaches, including milling process parameters (speed, process control agent atmosphere) and post-treatments (mechanical and thermal), are investigated on their suitability to influence the particle shape, especially concerning the roundness of the composite powders consisting of the aluminum alloy AlSi10Mg with 5 vol% SiC and Al2O3 reinforcement. It is found that milling with menthol as a process control agent leads to the finest composite powder compared to other milling parameters, with the lowest particle roundness of 0.39 (initial powders 0.84). No success in rounding the milled composite powder could be achieved through mechanical post-treatment in a planetary ball mill. On the other side, the thermal spraying of, e.g., SiC reinforced AlSi10Mg powder resulted in a 77–82% relative roundness. A remarkable change in the microstructure and the shape of the composite powders could also be observed after heat treatment in tube furnaces at a temperature above the melting point of AlSi10Mg. The best result in terms of improved roundness (relative to around 85%) was obtained for Al2O3 reinforced at 600 °C. A further increase of the temperature to 700 °C resulted in a moderate coarsening of powders with Al2O3 and extensive sintering of powders with SiC, presumably due to a different distribution inside the matrix.

High Dispersibility of Α-Al2o3 Powders from Coprecipitation Method by Step-by-step Horizontal Ball-Milling

Research on dispersion characteristics of micron grade Al_2O_3 particle in water phase

Research on Surface Modification and Dispersibility of Al_2O_3 in Liquid Wear-Resisting Layer

Influence of the Dispersant on the Bead Milling of Alumina

Effect of composite additives on phase transition and dispersibility of α-Al2O3

Preparation of α-Al2O3 by low-temperature calcining γ-Al2O3 with α-phase seed in-situ obtained by ball milling

Fabrication and Characterization of Mono-Dispersed Al2O3 Powders

Study On The Rheological Behavior Of Sub-Micron Alumina Aqueous Suspensions

Study on influence mechanism of surface active agent in preparing nano-sized zirconia powders by super-alkaline coprecipitation method

Homogeneous nanoparticle dispersion prepared with impurity-free dispersant by the ball mill technique

Enhancing Hydrogen‐Generation Performance of Γ‐al2o3 Modified Al Powder by Ultrasonic Dispersion

Surface Treatment and Modification of Al2O3 Powders

Lowering the synthesis temperature of α‐Al2O3 by increasing the content of pentacoordinate aluminum in the precursors

Effect of powder dispersity on the optical properties of HIP sintered MgAl2O4 transparent ceramics

Inter-particle interactions of alumina powders in UV-curable suspensions for DLP stereolithography and its effect on rheology, solid loading, and self-leveling behavior

Improvement in dispersion stability of alumina suspensions and corresponding chemical mechanical polishing performance

Controllable Preparation Conditions of Monodisperse γ-Al2O3 Nanoparticles

High-energy ball milling of Al2O3–TiO2 powders

Preparation of nano-sized 6MgO–2Y2O3–ZrO2 powders by a combined co-precipitation and high energy ball milling process

Influencing the Size and Shape of High-Energy Ball Milled Particle Reinforced Aluminum Alloy Powder

Effect of Dispersant on the Dispersibility of CaO–Al2O3-Based Mold Powder Slurry