Abstract:In order to clarify the effect of particle coagulation on the heat transfer properties, the governing equations of nanofluid together with the equation for nanoparticles in the SiO2/water nanofluid flowing through a turbulent tube are solved numerically in the range of Reynolds number 3000 <= Re <= 16,000 and particle volume fraction 0.005 <= phi <= 0.04. Some results are validated by comparing with the experimental results. The effect of particle convection, diffusion, and coagulation on the pressure drop increment P, particle distribution, and heat transfer of nanofluid are analyzed. The main innovation is that it gives the effect of particle coagulation on the pressure drop, particle distribution, and heat transfer. The results showed that increment P increases with the increase in Re and phi. When inlet velocity is small, the increase in increment P caused by adding particles is relatively large, and increment P increases most obviously compared with the case of pure water when the inlet velocity is 0.589 m/s and phi is 0.004. Particle number concentration M-0 decreases along the flow direction, and M-0 near the wall is decreased to the original 2% and decreased by about 90% in the central area. M-0 increases with increasing Re but with decreasing phi, and basically presents a uniform distribution in the core area of the tube. The geometric mean diameter of particle GMD increases with increasing phi, but with decreasing Re. GMD is the minimum in the inlet area, and gradually increases along the flow direction. The geometric standard deviation of particle diameter GSD increases sharply at the inlet and decreases in the inlet area, remains almost unchanged in the whole tube, and finally decreases rapidly again at the outlet. The effects of Re and phi on the variation in GSD along the flow direction are insignificant. The values of convective heat transfer coefficient h and Nusselt number Nu are larger for nanofluids than that for pure water. h and Nu increase with the increase in Re and phi. Interestingly, the variation in phi from 0.005 to 0.04 has little effect on h and Nu.

A Numerical Investigation of the Flow of Nanofluids Through a Micro Tesla Valve

Numerical investigation on forced convection in rectangular cross section micro-channels with nanofluids

The Hydraulic Cavitation Affected by Nanoparticles in Nanofluids

Convective Heat Transfer and Resistance Characteristics of Nanofluids with Cylindrical Particles

Numerical modeling and analysis of nanofluids subcooled boiling in a horizontal circular tube

Property of Water-Nanoparticle Flow and Heat Transfer in the Double-Tube Heat Exchanger with Nanofluid

Particle Distribution and Heat Transfer of SiO<sub>2</sub>/Water Nanofluid in the Turbulent Tube Flow

Numerical Research on Convective Heat Transfer and Resistance Characteristics of Turbulent Duct Flow Containing Nanorod-Based Nanofluids

An Experimental Investigation of Flow Phenomena in a Multistage Micro-Tesla Valve

Numerical Calculation of Gas–Liquid Two-Phase Flow in Tesla Valve

Numerical study on flow and heat transfer characteristics of a novel Tesla valve with improved evaluation method

Numerical Study of Flow and Heat Transfer Characteristics for Al2O3 Nanofluid in a Double-Pipe Helical Coil Heat Exchanger

Numerical study of the effects of geometric parameters and nanofluid properties on heat transfer and pressure drop in helical tubes

Numerical investigation of forced convection flow characteristics on hydrophobic surface with nanofluid

Numerical Study of Three-Dimensional Models of Single- and Two-Phase Nanofluid Flow through Corrugated Channels

Flow characteristics inside rectangular Tesla valve with different width-to-narrow ratios

Numerical Analysis of Unsteady Hybrid Nanofluid Flow Comprising CNTs-Ferrousoxide/Water with Variable Magnetic Field

Flow Characteristics of Heat and Mass for Nanofluid under Different Operating Temperatures over Wedge and Plate

Numerical analysis of electrothermoconvection of a dielectric nanofluid in a heated cavity

Thermal Analysis of Radiative Darcy-Forchheimer Nanofluid Flow Across an Inclined Stretching Surface

Flow and heat transfer characteristics of a nanofluid as the coolant in a typical MTR core