Abstract:The formation of water-conducting fractures in overlying strata caused by underground coal mining not only leads to roof water inrush disasters, but also water-conducting fractures penetrate the aquifer, resulting in the occurrence of a mine-water-inrush disaster and the loss of water resources. It destroys the sustainability of surface water and underground aquifers. This phenomenon is particularly significant in extra-thick coal seams and fault-bearing areas. Numerical simulation is an effective method to predict the failure range of mining overburden rock with low cost and high efficiency. The key to its accuracy lies in a reasonable constitutive model and simulation program. In this study, considering that the three parts of penetrating cracks, non-penetrating cracks, and intact rock blocks are often formed after rock failure, the contact state criterion and shear friction relationship of discrete rock blocks and the mixed fracture displacement–damage–load relationship are established, respectively. Combined with the Mohr–Coulomb criterion, the constitutive model of mining rock mass deformation–discrete block motion and interaction is formed. On this basis, according to the engineering geological conditions of Yushupo Coal Mine, a numerical model for the development of water-conducting cracks in the roof with faults under repeated mining of extra-thick coal seams is established. The results show the following: The constitutive relation of the continuous deformation–discrete block interaction of overlying strata and the corresponding finite element–discrete element FDEM numerical program and VUSDFLD multi-coal seam continuous mining subroutine can numerically realize the formation process of faults and water flowing fractures in overlying strata under continuous mining of extra-thick multi-coal seams. The toughness of sand mudstone is low, and the fracture will be further developed under the repeated disturbance of multi-thick coal seam mining. Finally, it is stabilized at 216–226 m, and the ratio of fracture height to mining thickness is 14.1. When the working face advances to the fault, the stress concentration occurs in the fault and its overlying rock, which leads to the local fracture of the roof rock mass and the formation of cracks. The fault group makes this phenomenon more obvious. The results have been preliminarily applied and tested in Ningwu mining area, which provides theoretical support for further development of roof water disaster control under the condition of an extra-thick coal seam and avoids the loss of water resources in surface water and underground aquifers.

Distribution Characteristics of the Additional Vertical Stress on a Shaft Wall in Thick and Deep Alluvium: a Simulation Analysis

Evaluation of the Additional Stress on Adjacent Tunnel Shafts Induced by Foundation Pit Excavation

Impact Of Aquifer Drainage On Shaft Lining In Underground Mining Of Eastern China

Simulation test on shaft deformation induced by mining subsidence under similar gravity field in deep soil strata

Field Monitoring and Numerical Simulation Analysis of Deep Shaft Concrete Wall Support

Analysis of Shaft Lining Water Irruption Mechanism in Coal Mine Based on Fluid-Solid Coupling Theory

Research on the required width of a fault waterproof coal pillar based on underground pressure control theory

Physical Simulation of the Water-Conducting Fracture Zone of Weak Roofs in Shallow Seam Mining Based on a Self-Designed Hydromechanical Coupling Experiment System

Test on Water-Level Stabilization and Prevention of Mine-Shaft Failure by Means of Groundwater Injection

Mechanical Analysis of the Failure Characteristics of Stope Floor Induced by Mining and Confined Aquifer

Shaft Failure Characteristics and the Control Effects of Backfill Body Compression Ratio at Ultra-Contiguous Coal Seams Mining

Floor Failure Characteristics in Deep Island Longwall Panel: Theoretical Analysis and Field Verification

Physical Simulation on Weakly Cemented Aquiclude Stability due to Underground Coal Mining

Physical modeling of floor failure above confined water: a case study in China

Similarity simulation study on displacement and stress changes response to coal mining in Longdong coal mine, China

Investigating Disaster Mechanisms Triggered by Abrupt Overburden Fracture Alterations in Close-Seam Mining Beneath an Exceptionally Thick Sandstone Aquifer

Finite–Discrete Element Method Simulation Study on Development of Water-Conducting Fractures in Fault-Bearing Roof under Repeated Mining of Extra-Thick Coal Seams

Fracture Propagation and Hydraulic Properties of a Coal Floor Subjected to Thick-Seam Longwalling above a Highly Confined Aquifer

Influence Analysis of Mining’s Effect on Failure Characteristics of a Coal Seam Floor with Faults: A Numerical Simulation Case Study in the Zhaolou Coal Mine

Simulation of the Uniaxial Mechanical Properties and Crack Evolution of Coal Pillar-artificial Dam in Abandoned Mines

The fracturing characteristics of rock mass of coal mining and its effect on overlying unconsolidated aquifer in Shanxi, China