Abstract:The influence of strain on the behaviors of gas molecules over surface is always limited by the relative weak gas adsorption, the small range of elastic strain of adsorbents and the uniform response of surface sites. However, the latter two factors may be overcome in two-dimensional (2D) materials with defects. In this work, we employ first-principles calculations to investigate the behavior of a series of common gas molecules (CO, CO 2 , NH 3 , SO 2 , NO, NO 2 and O 2 ) on defective (S vacancies and non-metal C/N/O doped) MoS 2 monolayers in both the 2H and 1T′ phases under biaxial strain (± 5%). When defects are introduced, strain can cause the gas molecules around the defects to physically/chemically adsorb, desorb, dissociate or even react with dopant. Meanwhile, the mechanical energy consumed to generate strain can be effectively transferred to change the energy of adsorption/desorption/reaction of adsorbates with an efficiency of at least 15% (if only adsorption strength is altered) up to 200% (if reaction is triggered). Subsequently, a number of interesting phenomena can be observed. For example, the doping-and-undoping cycle (e.g., the C doping of 2H-MoS 2 and N doping of 1T′-MoS 2 monolayers) can be dynamically controlled by pumping relevant gases and applying proper strain. Reversible adsorption and desorption of NH 3 on defective MoS 2 monolayers in both phases can be achieved within ± 3% strain. NO or NO 2 and CO can be converted into non-toxic N 2 O and CO 2 over the N-doped (3% strain) and O-doped (− 3% strain) 1T′-MoS 2 monolayers. In essence, defective 2D materials can serve as ideal multi-purpose platforms for strain engineering the behaviors of adsorbates.

Ligand induced structure and property changes of 1T-MoS 2 .

Ligand induced structure and property changes of 1T-MoS<sub>2</sub>

Pressure confinement effect in MoS2 monolayers.

Modulation of Gas Adsorption and Magnetic Properties of Monolayer-MoS2 by Antisite Defect and Strain

Chemically-exfoliated single-layer MoS$_2$ : stability, lattice dynamics and catalytic adsorption from first principles

First-principles study of transition-metal atoms adsorption on MoS2 monolayer

2H → 1T′ phase transformation in Janus monolayer MoSSe and MoSTe: an efficient hole injection contact for 2H-MoS2

Electronic and magnetic properties of the superhalogen Fe(NO3)3 absorbed monolayer MoS2: The regulating performance

Strain Engineering the Behaviors of Small Molecules over Defective MoS2 Monolayers in the 2H and 1T′ Phases

Phase-selective Synthesis of 1T′ MoS2 Monolayers and Hetero-Phase Bilayers

Metastable Phase Control of Two-Dimensional Transition Metal Dichalcogenides on Metal Substrates

First-Principles Study On Structural, Thermal, Mechanical And Dynamic Stability Of T'-Mos2

First Principles Study on Molecule Doping in MoS2 Monolayer

Metastable MoS2: crystal structure, electronic band structure, synthetic approach and intriguing physical properties.

A General Strategy to Stabilize the 1T-MoS2 by Using MXene Heterostructures and Unlock Its Hydrogen Evolution Reaction Capabilities

Structures and phase transition of a MoS2 monolayer

Unraveling States, Energetics, and Kinetics of Adsorbing Oxygen Species above MoS2

Electronic and Transport Properties of 2H 1−x 1T X MoS 2 Hybrid Structure: A First-Principle Study

A General Strategy to Stabilize 1T-Mos2 Using MXene Heterostructures and Unlock Its Hydrogen Evolution Reaction Capabilities.

Air Stable and Reversible N-Type Surface Functionalization of MoS2 Monolayer Using Arg and Lys Amino Acids

In-Plane Anisotropic Properties Of 1t '-Mos2 Layers