Abstract:Solute diffusion flux in soil is described by Fick's law along with a tortuosity factor to account for the tortuous and reduced diffusive pathway blocked by soil particles. Predictive models based on empirical or conceptual relationships with other more commonly measured soil attributes have been proposed to replace the time-consuming and multifarious laboratory measurements. However, these models have not been systematically tested and evaluated with soils of different textures under comparable conditions. This study determined solute diffusion coefficients and calculated tortuosity factors of a sand, a sandy clay loam, and a clay at various degrees of water saturation, and used the experimental data to test the predictive capabilities of these models. All the test models can fit the experimental data reasonably well as evidenced by low root mean square errors (RMSEs). When the proposed (fixed) parameter values were used, the widely accepted Millington and Quirk tortuosity model resulted in highest RMSEs for all three test soils. In terms of model efficiency as described by Akaike weight, however, the tortuosity factors of the sand and sandy clay loam soils are best represented by a quadratic function of volumetric soil water content (with the largest Akaike weights), while the combined parallel-series conceptual model assuming different configurations of film and pore water is the best for the clay soil. The Olesen power function tortuosity model has the second largest Akaike weights for the sand and sandy clay loam soils, while the So and Nye linear model has the second largest Akaike weight for the clay soil. The two-region linear model of log (tortuosity factor) versus soil water content uses a similar framework to the conceptual model, and it can satisfactorily fit to the experimental data well (low RMSEs), but with low Akaike weights due to the large number of parameters in the model. Adaption of the findings from this study may substantially improve solute diffusion modeling in unsaturated porous media.

Quantification of the Transparency of the Transparent Soil in Geotechnical Modeling

Development of transparent cemented soil for geotechnical laboratory modelling

Quantitative Analysis of Soft Clay Three-dimensional Porosity Based on SEM Image Information

Experimental Study on the Permeability Characteristic of Fused Quartz Sand and Mixed Oil as a Transparent Soil

Experimental Study on the Time-Dependent Characteristics of MLPS Transparent Soil Strength

An Improved Quantification Method for Characterisation of Clay Microstructure Using SEM

SOFT SOIL THREE-DIMENSIONAL POROSITY CALCULATED BASE ON SEM IMAGE AND ITS INFLUENCE FACTORS ANALYSIS

Quantification and Characterization of Microporosity by Image Processing, Geometric Measurement and Statistical Methods: Application on Sem Images of Clay Materials

Model tests on displacement field of internal soil induced by laterally loading pile

Triaxial Tests on Deformation Characteristics of Transparent Glass Sand

Quantification Of Microstructure Of Fine Grained Soil

Effect of different pore fluids on the dynamic behavior of transparent sand

Quantifying Representative Elementary Volume of Connectivity for Translucent Granular Materials by Light Transmission Micro-Tomography

Full-field internal 3D deformations measurement of transparent soil using 3D-DIC combined with optical slicing

Evaluation of solute diffusion tortuosity factor models for variously saturated soils

3D Visualization and Porosity Computation of Clay Soil SEM Image by GIS

Quantitative analysis of pore-size influence on granite residual soil permeability using CT scanning

Current Status of Digital Image Based Quantitative Analysis of Internal Structures of Soils, Rocks and Concretes and Associated Numerical Simulation

3D Quantitative Characterization of Fractures and Cavities in Digital Outcrop Texture Model Based on Lidar

Quantification of the pore size distribution of soils: Assessment of existing software using tomographic and synthetic 3D images

Transparent soil model test and numerical study on the effect of adjacent spring on the stability of tunnel face in composite strata