Abstract:As tellurides and selenides of Bismuth are extensively used thermoelectric materials in the low-temperature range with refrigeration application, A concerted effort is put forth to boost the ZT by co-doping the pristine Bi 2 Se 3 with antimony (Sb) on cation end and tellurium (Te) on anion side of the compound. The double sintered solid-state reaction method is employed in the preparation of Bi 2 Se 3 and (Bi 1− x Sb x ) 2 Se 2.7 Te 0.3 polycrystalline pellets, with x = 0.02, 0.04, and 0.06. The sample exhibits a rhombohedral structure with the space group of R m. FESEM and EDAX analysis are used to confirm surface morphology and elemental composition of the produced samples. The thermoelectric measurements for the pristine and co-doped samples were conducted by the physical property measurement system as well as a considerable increase in the Seebeck coefficient of − 115 μV/K is observed for 0.02 doping of the Sb which is 4.2 times greater than as for pristine (S = − 28 μV/K). Higher concentration doping ( x = 0.04, 0.06) has not reflected any Seebeck coefficient advancement. In contrast, the lowest total thermal conductivity at a low-temperature regime (< 50 K) is observed for x = 0.06 doping concentration which at near room temperature increases beyond the pristine thermal conductivity; whereas, x = 0.02, 0.04 doping concentration shows a decrement in total thermal conductivity at low, at room temperature region the values are almost equivalent to that of pristine. The co-doped samples' electrical resistivity is substantially less than pristine sample. The highest power factor of 3 × 10 –4 μW/mK 2 is obtained for the x = 0.02 sample. The highest ZT value for the x = 0.02 sample is almost 28 times more than a pristine sample. We conducted a study where we combined experimental and DFT methods to investigate thermoelectric properties incorporated into pristine and doped with antimony and tellurium on Bi 2 Se 3 . We have employed this combination to investigate the partial density of states, Seebeck coefficient, power factor using the Boltzmann transport equation. Theoretical thermoelectric data were derived and compared to experimental observations. Hence, using combined experimental and theoretical investigations helps to predict with higher accuracy of thermoelectric properties of semiconducting materials.

First-principles Study of the Thermoelectric Properties of Quaternary Tetradymite BiSbSeTe2

Enhanced Thermoelectric Performance of (Sb0.75bi0.25)(2)te-3 Compound from First-Principles Calculations

A cytopathic effect of Trichomonas vaginalis probably mediated by a mannose/N-acetyl-glucosamine binding lectin.

High-Temperature Thermoelectric Monolayer Bi 2 TeSe 2 with High Power Factor and Ultralow Thermal Conductivity

Low Lattice Thermal Conductivity Induced by Antibonding Sp-Hybridization in Sb2Sn2Te6 Monolayer with High Thermoelectric Performance: First-principles Calculations

Integrating band engineering with point defect scattering for high thermoelectric performance in Bi2Si2Te6

Enhancement of thermoelectric properties over a wide temperature range by lattice disorder and chemical potential tuning in a (CuI) y (Bi2Te3)0.95- x (Bi2Se3) x (Bi2S3)0.05 quaternary system

Rational triple optimizations boost near-room-temperature thermoelectric performance of BiSe

Thermoelectric Performance of Binary Lithium-Based Compounds: Li3Sb and Li3Bi

BiSbSe3: A promising Te-free thermoelectric material

Thermoelectric performance of binary lithium-based compounds: Li 3 Sb and Li 3 Bi

Thermoelectric performance of Bi2Sn2Te6 monolayer with ultralow lattice thermal conductivity induced by hybrid bonding properties: A theoretical prediction

Anisotropic thermoelectric transport properties of Bi0.5Sb1.5Te2.96+x zone melted ingots

Temperature dependence of structural, dynamical, and electronic properties of amorphous Bi2Te3: an ab initio study

Electronic and thermoelectric properties of semiconducting Bi2SSe2 and Bi2S2Se monolayers with high optical absorption.

Cu$_2$ZnSiTe$_4$: A potential thermoelectric material with promising electronic transport

Band Modification Towards High Thermoelectric Performance of SnSb2Te4 with Strong Anharmonicity Driven by Cation Disorder

Nanostructuring and improved performance of ternary Bi–Sb–Te thermoelectric materials

Complex Electronic Structure and Compositing Effect in High Performance Thermoelectric BiCuSeO.

Thermoelectric performance of (AgBiTe2)1-x(SnTe)x with stable cubic enabled by enhanced configurational entropy

A comprehensive experimental and DFT analysis on thermoelectric properties of Sb, Te co-doped Bi2Se3 polycrystals