Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Denitration by Oxidation-Absorption with Polypropylene Hollow Fiber Membrane Contactor

Removal of NO Research in A Polypropylene Hollow Fiber Membrane Contactor

Experimental Study on the NO Oxidation and Removal by Heterogeneous Fenton Reaction

Removal of NOX Using Hydrogen Peroxide Vapor over Fe/TiO2 Catalysts and an Absorption Technique

A Superior Liquid Phase Catalyst for Enhanced Absorption of NO2 Together with SO2 after Low Temperature Ozone Oxidation for Flue Gas Treatment

Experimental study on three additives used for the removal of nitrite, a byproduct of ozone oxidation denitration technology

Microporous polypropylene hollow fiber membranes contactor for the separation and fixation of carbon dioxide from simulative flue gas

Wet Oxidation and Absorption Procedure for NOx Removal

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

Nitrogen Removal from Sludge Dewatering Effluent Through Anaerobic Ammonia Oxidation Process.

Mechanistic Study on the Removal of NO 2 from Flue Gas Using Novel Ethylene Glycol-tetrabutylammonium Bromide Deep Eutectic Solvents

Sustainable Conversion and Cleanup Emission of Ultralow-Concentration Nitric Oxide in Flue Gas by Functionalized Ionic Liquids in the Presence of Water and Air under Elevated Pressure

Experimental studies on simultaneous removal of CO2 and SO2 in a polypropylene hollow fiber membrane contactor

Effects of Operating and Structural Parameters on Removal of Nitric Oxide by Oxidation in a Ceramic Hollow Fiber Membrane Contactor

Removal of NO and SO_2 from Flue Gas by Wet Scrubbing Using Aqueous NaClO Solution

Engineering Practice and Economic Analysis of Ozone Oxidation Wet Denitrification Technology

Simultaneous Removal of SO2 and NOx with Ammonia Combined with Gas-Phase Oxidation of NO Using Ozone

Room Temperature Efficient Reduction of NOx by H2 in a Permeable Compounded Membrane – Catalytic Reactor

Selective Sulfur Dioxide Absorption from Simulated Flue Gas Using Various Aqueous Alkali Solutions in a Polypropylene Hollow Fiber Membrane Contactor: Removal Efficiency and Use of Sulfur Dioxide

Using Chlorine Dioxide to Remove NOx in Low-Temperature Flue Gas

Removal of Nitric Oxide from Simulated Flue Gas Via Denitrification in a Hollow-Fiber Membrane Bioreactor.