Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Novel Simultaneous Removal Technology of NO and SO2 Using a Semi-Dry Microwave Activation Persulfate System

Simultaneous Absorption of SO2 and NO from Flue Gas Using Ultrasound/fe2+/heat Coactivated Persulfate System

A Superior Liquid Phase Catalyst for Enhanced Absorption of NO2 Together with SO2 after Low Temperature Ozone Oxidation for Flue Gas Treatment

Novel Method for High-Performance Simultaneous Removal of NOx and SO2 by Coupling Yellow Phosphorus Emulsion with Red Mud

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

A Novel Double Metal Ions-Double Oxidants Coactivation System for NO and SO2 Simultaneous Removal

Simultaneous Removal of SO2 and NO by FeII(EDTA) Solution: Promotion of Mn Powder and Mechanism of Reduction

The simultaneous removal of SO2 and NO from flue gas over activated coke in a multi-stage fluidized bed at low temperature

Oxidation and absorption of SO2 and NOx by MgO/Na2S2O8 solution at the presence of Cl−

Experimental Research for the Simultaneous Removal of NOx and SO2 in Flue Gas by O3

Recent advances in simultaneous removal of SO2 and NOx from exhaust gases: Removal process, mechanism and kinetics

Simultaneous removal of SO2 and NOx by combination of ozone oxidation and Na2S2O3solution spray

Study on the collaborative removal of multi-pollutants from flue gas

Disposal of Low Concentration Fume with Solid Waste Modified by Microwave.

Multi-stage semi-coke activation for the removal of SO2 and NO

Removal of NO and SO_2 from Flue Gas by Wet Scrubbing Using Aqueous NaClO Solution

Removal of NO in Flue Gas Using Vacuum Ultraviolet Light/ultrasound/chlorine in a VUV-US Coupled Reactor

O3 oxidation combined with semi-dry method for simultaneous desulfurization and denitrification of sintering/pelletizing flue gas

Simultaneous removal of NOx and SO2 from flue gas using combined Na2SO3 assisted electrochemical reduction and direct electrochemical reduction

Novel process of NO removal from simulated flue gas using a Fe/Gr periodically reversing electro-activated peroxymonosulfate system

Removal of SO2 and NOx from flue gas using mud-phosphorus slurry