Abstract:Diketopyrrolopyrrole (DPP) is attractive for building conjugated polymers for polymer solar cell (PSC) and organic field effect transistor (OFET). Yet the usual access to DPP conjugated polymers is via donor-acceptor (D-A) two-component polymerization. However, the number of excellent polymers based on the D-A combination is still limited, which promotes researchers to explore new strategy for preparation of novel conjugated polymers and to understand their structure-property relationship. In this work, a DPP-based polymer P1 was first obtained with co-polymerization of DPP (A) and alkoxyl benzene (D). Further, two novel polymers (P2 and P3) were developed via introducing a third electron-deficient monomer X (difluoro-benzothiadiazole or naphthalene diimide) in the polymerization process. P1 - P3 polymers (molecular weight: 3.83 x 10(4), 5.30 x 10(4) and 6.56 x 10(4)) showed good solubility in common organic solvents. Due to the hybridization of the molecular orbitals between their three components (D, A and X), P2 and P3 showed narrower bandgaps (1.26 and 1.27 eV) than P1, and their absorption thus red-shifted up to 1000 nm in comparison to that of D-A polymer P1 (bandgap of 1.50 eV). The introduction of electron-deficient monomers also deepened the highest occupied molecular orbital (HOMO) levels of P2 and P3 to -5.28 and -5.33 eV, which was beneficial to a larger open circuit voltage (V-OC) in PSCs. Moreover, the introduction of the third monomer X altered the film properties of the polymers. It showed that P1 with preference of face-on orientation exhibited a good power conversion efficiency (PCE) in PSCs, while P2 demonstrated an improved hole mobility in OFET due to the preferable edge-on orientation. When blended with [6,6]-phenyl-C-71-butyric acid methyl ester (PC71BM), P1 showed a PCE of 2.56%, with a V-OC of 0.68 V, a short circuit current density (J(SC)) of 5.71 mA cm(-2) and a fill factor (FF) of 0.66, while P2 gave a lower PCE of 1.79%, with a V-OC of 0.71 V, a J(SC) of 3.91 mA cm(-2) and a FF of 0.65. This work provides references for the design of novel conjugated polymers for PSCs and OFETs.

Narrow Bandgap Semiconducting Polymers for Solar Cells with Near-Infrared Photo Response and Low Energy Loss

Low-Bandgap DPP-Based Quinoxaline with Extended EQE and Low Energy Loss for Efficient Polymer Solar Cells

Dithienopicenocarbazole-Based Acceptors For Efficient Organic Solar Cells With Optoelectronic Response Over 1000 Nm And An Extremely Low Energy Loss

A Wide-Bandgap Conjugated Polymer Based on Quinoxalino[6,5-f ]quinoxaline for Fullerene and Non-Fullerene Polymer Solar Cells

ChemInform Abstract: Review on the Recent Progress in Low Band Gap Conjugated Polymers for Bulk Hetero‐Junction Polymer Solar Cells

N-Type Quinoidal Polymers Based on Dipyrrolopyrazinedione for Application in All-Polymer Solar Cells

The photovoltaic behaviors of PPV- and PPE-type conjugated polymers featured with diketopyrrolopyrrole (DPP) units

Synthesis And Photovoltaic Properties From Inverted Geometry Cells And Roll-To-Roll Coated Large Area Cells From Dithienopyrrole-Based Donor-Acceptor Polymers

Review on the Recent Progress in Low Band Gap Conjugated Polymers for Bulk Hetero‐junction Polymer Solar Cells

Diketo-Pyrrolo-Pyrrole-Based Medium Band Gap Copolymers for Efficient Plastic Solar Cells: Morphology, Transport, and Composition-Dependent Photovoltaic Behavior

Synthesis, Characterization, and Photovoltaic Property of a Low Band Gap Polymer Alternating Dithienopyrrole and Thienopyrroledione Units

Design and Synthesis of Dithieno[3,2‐b:2′3′‐D]pyrrole‐based Conjugated Polymers for Photovoltaic Applications: Consensus Between Low Bandgap and Low HOMO Energy Level

Quinoxaline‐Based D–A Copolymers for the Applications as Polymer Donor and Hole Transport Material in Polymer/Perovskite Solar Cells

Design and Synthesis of Wide-bandgap Conjugated Polymers Based on 3,4-Dicyanothiophene for Efficient Organic Solar Cells

New –(d–a1–d–a2)n– Type Conjugated Polymers for Photovoltaic Applications: Consensus Between Low Band-Gap and Low HOMO Energy Level

FLUORENE-BASED COPOLYMERS FOR RED LIGHT-EMITTING DIODES AND BULK HETEROJUNCTION PHOTOVOLTAIC CELL

Novel Two‐dimensional Donor–acceptor Conjugated Polymers Containing Quinoxaline Units: Synthesis, Characterization, and Photovoltaic Properties

A Copolymer Based on Benzo[1,2-B:4,5-B′]dithiophene and Quinoxaline Derivative for Photovoltaic Application

Photovoltaic Properties of DPP-based Two- and Three-component Polymers

Pyridine-bridged diketopyrrolopyrrole conjugated polymers for field-effect transistors and polymer solar cells

N-acyldithieno[3,2-b:2',3'-d]pyrrole-based Low-Band-gap Conjugated Polymer Solar Cells with Amine-Modified [6,6]-Phenyl-c61-butyric Acid Ester Cathode Interlayers.