Abstract:In the polymer solar cells research field, dithieno[3,2-b:2',3'-d]pyrrole (DTP) is a good donor unit due to its good planarity when it is used as build donor-acceptor (D-A) polymer. In this work, three DTP based polymers (named P1, P2, P3) are synthesized by polymerizing DTP with DPP, DTBO and TQ co-monomer acceptor unit, respectively. These three polymers exhibit good solubility in common solvent such as dichlorobenzene. GPC results show that the polymers show moderate number-average molecular weights (M-n, 9 x 10(3) to 2.2 x 10(4)) and narrow PDI (1 - 2). UV-Vis absorption spectra in solution and thin film show that the polymers have a relatively narrow band gap (P1: 1.23 eV; P2: 1.51 eV; P3: 1.50 eV), which enhances the polymer absorption of sunlight, with P1 showing the widest absorption (extending UV-Vis absorption to nearly 1000 nm). The thermal property of these polymers is measured by thermogravimetric analysis (TGA), giving their T-d located at 313 - 410 degrees C. The highest occupied molecular orbital (HOMO) energy levels of the polymers are between -5.2 eV and -5.4 eV, as tested by CV method. Photovoltaic devices are fabricated with P1 - P3 as donor and PC71BM as acceptor in active layer. The solar cells J-V test results reveal that P1 has the highest PCE of 3.33% with J(SC) of 15.82 mA/cm(2), V-OC of 0.38 V when the mass ratio of P1 to PC71BM is kept at 1:3. The relative high PCE of P1 based PSCs devices is due to the wide light absorption, leading to high J(SC) of PSCs devices, which also can be confirmed by external quatum efficiency (EQE) test. For the polymers P2 and P3, with the mass ratio of polymer/PC71BM at 1:2, PCE of 1.20% for P2 and 1.37% of P3 are achieved respectively, and the relatively low PCE is caused by low short circuit current density (J(SC)) (P2: 9.70 mA/cm(2), P3: 9.21 mA/cm(2)) and the low open-circuit voltage (V-OC, only around 0.3 V). Transmission electron microscopy is also used to explore the polymer solar cells active layer morphology, which correlates closely with the donor and the acceptor aggregations and the phase separation.

Diketo-Pyrrolo-Pyrrole-Based Medium Band Gap Copolymers for Efficient Plastic Solar Cells: Morphology, Transport, and Composition-Dependent Photovoltaic Behavior

Bandgap And Molecular Level Control Of The Low-Bandgap Polymers Based On 3,6-Dithiophen-2-Yl-2,5-Dihydropyrrolo[3,4-C]Pyrrole-1,4-Dione Toward Highly Efficient Polymer Solar Cells

Three Pyrido[2,3,4,5-Lmn]phenanthridine Derivatives and Their Large Band Gap Copolymers for Organic Solar Cells

Synthesis and Photovoltaic Performance of Low Band Gap Dithieno[3,2-b:2 ',3 '-D]pyrrole-based Conjugated Copolymers

Synthesis And Photovoltaic Properties From Inverted Geometry Cells And Roll-To-Roll Coated Large Area Cells From Dithienopyrrole-Based Donor-Acceptor Polymers

Side-chain engineering of medium bandgap polymer donors for efficient polymer solar cells

Molecular engineering of copolymers with donor-acceptor structure for bulk heterojunction photovoltaic cells toward high photovoltaic performance

Acceptor-rich Bulk Heterojunction Polymer Solar Cells with Balanced Charge Mobilities

Synthesis and Photovoltaic Performance of Low Band Gap Copolymers Based on Diketopyrrolopyrrole and Tetrathienoacene with Different Conjugated Bridges

Two-dimensional Like Conjugated Copolymers for High Efficiency Bulk-Heterojunction Solar Cell Application: Band Gap and Energy Level Engineering

Manipulating backbone structure to enhance low band gap polymer photovoltaic performance

ChemInform Abstract: Review on the Recent Progress in Low Band Gap Conjugated Polymers for Bulk Hetero‐Junction Polymer Solar Cells

A diketopyrrolopyrrole-based low bandgap polymer with enhanced photovoltaic performances through backbone twisting

A(1)-A(2) Type Wide Bandgap Polymers for High-Performance Polymer Solar Cells: Energy Loss and Morphology

Development of New Conjugated Polymers with Donor-Pi-Bridge-Acceptor Side Chains for High Performance Solar Cells

Development Of Large Band-Gap Conjugated Copolymers For Efficient Regular Single And Tandem Organic Solar Cells

N-acyldithieno[3,2-b:2',3'-d]pyrrole-based Low-Band-gap Conjugated Polymer Solar Cells with Amine-Modified [6,6]-Phenyl-c61-butyric Acid Ester Cathode Interlayers.

Low Band‐gap D–A Conjugated Copolymers Based on Anthradithiophene and Diketopyrrolopyrrole for Polymer Solar Cells and Field‐effect Transistors

Backbone regulation of a bithiazole-based wide bandgap polymer donor by introducing thiophene bridges towards efficient polymer solar cells

Synthesis, Characterization, and Photovoltaic Properties of Carbazole-Based Two-Dimensional Conjugated Polymers with Donor-π-Bridge-Acceptor Side Chains

Two New Medium Bandgap Asymmetric Copolymers Based on Thieno[2,3-F]benzofuran for Efficient Organic Solar Cells