Abstract:Diketopyrrolopyrrole (DPP) is attractive for building conjugated polymers for polymer solar cell (PSC) and organic field effect transistor (OFET). Yet the usual access to DPP conjugated polymers is via donor-acceptor (D-A) two-component polymerization. However, the number of excellent polymers based on the D-A combination is still limited, which promotes researchers to explore new strategy for preparation of novel conjugated polymers and to understand their structure-property relationship. In this work, a DPP-based polymer P1 was first obtained with co-polymerization of DPP (A) and alkoxyl benzene (D). Further, two novel polymers (P2 and P3) were developed via introducing a third electron-deficient monomer X (difluoro-benzothiadiazole or naphthalene diimide) in the polymerization process. P1 - P3 polymers (molecular weight: 3.83 x 10(4), 5.30 x 10(4) and 6.56 x 10(4)) showed good solubility in common organic solvents. Due to the hybridization of the molecular orbitals between their three components (D, A and X), P2 and P3 showed narrower bandgaps (1.26 and 1.27 eV) than P1, and their absorption thus red-shifted up to 1000 nm in comparison to that of D-A polymer P1 (bandgap of 1.50 eV). The introduction of electron-deficient monomers also deepened the highest occupied molecular orbital (HOMO) levels of P2 and P3 to -5.28 and -5.33 eV, which was beneficial to a larger open circuit voltage (V-OC) in PSCs. Moreover, the introduction of the third monomer X altered the film properties of the polymers. It showed that P1 with preference of face-on orientation exhibited a good power conversion efficiency (PCE) in PSCs, while P2 demonstrated an improved hole mobility in OFET due to the preferable edge-on orientation. When blended with [6,6]-phenyl-C-71-butyric acid methyl ester (PC71BM), P1 showed a PCE of 2.56%, with a V-OC of 0.68 V, a short circuit current density (J(SC)) of 5.71 mA cm(-2) and a fill factor (FF) of 0.66, while P2 gave a lower PCE of 1.79%, with a V-OC of 0.71 V, a J(SC) of 3.91 mA cm(-2) and a FF of 0.65. This work provides references for the design of novel conjugated polymers for PSCs and OFETs.

Design and Synthesis of Dithieno[3,2‐b:2′3′‐D]pyrrole‐based Conjugated Polymers for Photovoltaic Applications: Consensus Between Low Bandgap and Low HOMO Energy Level

New –(d–a1–d–a2)n– Type Conjugated Polymers for Photovoltaic Applications: Consensus Between Low Band-Gap and Low HOMO Energy Level

Synthesis and Photovoltaic Performance of Low Band Gap Dithieno[3,2-b:2 ',3 '-D]pyrrole-based Conjugated Copolymers

The photovoltaic behaviors of PPV- and PPE-type conjugated polymers featured with diketopyrrolopyrrole (DPP) units

Synthesis, Characterization, and Photovoltaic Property of a Low Band Gap Polymer Alternating Dithienopyrrole and Thienopyrroledione Units

Bandgap And Molecular Level Control Of The Low-Bandgap Polymers Based On 3,6-Dithiophen-2-Yl-2,5-Dihydropyrrolo[3,4-C]Pyrrole-1,4-Dione Toward Highly Efficient Polymer Solar Cells

Synthesis And Photovoltaic Properties From Inverted Geometry Cells And Roll-To-Roll Coated Large Area Cells From Dithienopyrrole-Based Donor-Acceptor Polymers

A diketopyrrolopyrrole-based low bandgap polymer with enhanced photovoltaic performances through backbone twisting

Synthesis of low bandgap polymer based on 3,6-dithien-2-yl-2,5-dialkylpyrrolo[3,4-c]pyrrole-1,4-dione for photovoltaic applications

Photovoltaic Properties of DPP-based Two- and Three-component Polymers

Synthesis, Characterization, Charge Transport, and Photovoltaic Properties of Dithienobenzoquinoxaline- and Dithienobenzopyridopyrazine-Based Conjugated Polymers

Synthesis and Characterization of New Thieno[3,4-C] Pyrrole-4,6-Dione Derivatives for Photovoltaic Applications

N-acyldithieno[3,2-b:2',3'-d]pyrrole-based Low-Band-gap Conjugated Polymer Solar Cells with Amine-Modified [6,6]-Phenyl-c61-butyric Acid Ester Cathode Interlayers.

Pyrene-benzothiadiazole-based Copolymers for Application in Photovoltaic Devices

Synthesis and photovoltaic application of low-bandgap conjugated polymers by incorporating highly electron-deficient pyrrolo[3,4-d]pyridazine-5,7-dione units

Low bandgap copolymer of 1,4-diketopyrrolo[3,4-c]pyrrole and thieno[3,2-b]thiophene: Synthesis and applications in polymer solar cells and field-effect transistors

Synthesis And Photovoltaic Properties Of Conjugated D-A Copolymers Based On Thienyl Substituted Pyrene And Diketopyrrolopyrrole For Polymer Solar Cells

Benzo[2,1‐b;3,4‐b′]dithiophene‐based low‐bandgap polymers for photovoltaic applications

Synthesis and Photovoltaic Properties of Conjugated Copolymers Containing Cyclopentadithiophene and Two Different Electron-Deficient Moieties in the Polymer Backbone

Incorporation of ester groups into low band-gap diketopyrrolopyrrole containing polymers for solar cell applications

Synthesis and Photovoltaic Properties of Low‐bandgap 4,7‐dithien‐2‐yl‐2,1,3‐benzothiadiazole‐based Poly(heteroarylenevinylene)s