Abstract:Separation of carbon dioxide from a humid mixture of CO2-N-2 through membranes containing immobilized solutions of Na2CO3-glycerol in porous and hydrophilic poly(vinylidene fluoride) (PVDF) substrate was experimentally studied for use as a venting membrane in space-walk applications. The effects of Na2CO3 concentration, CO2 partial pressure, and feed stream relative humidity (RH) were investigated. The carbonate concentration was in the range of 0-4.0 mol/dm(3). The feed gas RH range was 49-100%; the sweep gas was dry helium. CO2 partial pressure (p(CO2,f)) range was 0.007-0.77 arm. Addition of Na2CO3 increased the CO2 permeability drastically at lower carbonate concentrations; at higher Na2CO3 concentrations, this permeability increase is partly compromised by increased solution viscosity and salting-out effect. N-2 permeability coefficient decreased with an increase in Na2CO3 concentration. Very high CO2/N-2 selectivities were observed at high Na2CO3 concentrations. Higher CO2/N-2 selectivities were observed at lower CO2 partial pressure differentials. Steady-state water content in the hygroscopic immobilized liquid membrane (ILM) increases with an increase in feed stream RH. The water content in the ILM considerably affects its viscosity and the effective concentration of the carriers in the ILM; those factors determine the permeation performances of the ILM. Generally, lower permeances and greater CO2/N-2 selectivity values were observed at lower feed stream RHs. When the feed RH = 50.7%, P-CO2,P-f = 0.007 atm and the Na2CO3 concentration was 1.0 mol/dm(3); the separation factor alpha(CO2/N-2) observed was 3440. Prolonged runs lasting 14 days showed that the ILM permeation performances were quite stable. The ILMs were also found to be stable when challenged with feed streams of very low RHs.

Wet CO2/N2 Permeation through a Crosslinked Thermally Rearranged Poly(benzoxazole-co-imide) (XTR-PBOI) Hollow Fiber Membrane Module for CO2 Capture

Selective CO2 Separation from CO2−N2 Mixtures by Immobilized Carbonate−Glycerol Membranes

Thermally rearranged poly(benzoxazole -co- imide) hollow fiber membranes for CO 2 capture

Ternary Mixed-Gas Separation for Flue Gas CO2 Capture Using High Performance Thermally Rearranged (TR) Hollow Fiber Membranes

Thermally rearranged (TR) polybenzoxazole hollow fiber membranes for CO2 capture

Fabrication of Sub-Tg Cross-Linked and Thermally Rearranged Poly (Benzoxazole-Co-imide) Hollow Fiber Membrane Derived from Phenolphthalein-Based Copolyimide for CO2/CH4 Separation

Fabrication of thermally rearranged (TR) polybenzoxazole hollow fiber membranes with superior CO 2 /N 2 separation performance

Sub-Tg Cross-Linked Thermally Rearranged Polybenzoxazole Derived from Phenolphthalein Diamine for Natural Gas Purification

Cross-Linked Thermally Rearranged Poly(Benzoxazole-Co-Imide) Membranes for Gas Separation

Thin-film Composite Membranes Based on Hyperbranched Poly(ethylene Oxide) for CO2/N2 Separation

Cross-Linked Thermally Rearranged Poly(benzoxazole- co -imide) Membranes Prepared from ortho -Hydroxycopolyimides Containing Pendant Carboxyl Groups and Gas Separation Properties

Highly Permeable and Selective Poly(benzoxazole-Co-imide) Membranes for Gas Separation

Blended Crosslinked Polybenzoxazole (PBO) Membranes Derived from Phenolphthalein-Based Polyamide and Polyimide for CO2/CH4 Gas Separation

Thermally Rearranged Poly(Benzoxazole-Co-Imide) Membranes with Superior Mechanical Strength for Gas Separation Obtained by Tuning Chain Rigidity

Dimensionally-controlled Densification in Crosslinked Thermally Rearranged (XTR) Hollow Fiber Membranes for CO2 Capture

Thermally rearranged (TR) poly(benzoxazole-co-amide) membranes for hydrogen separation derived from 3,3′-dihydroxy-4,4′-diamino-biphenyl (HAB), 4,4′-oxydianiline (ODA) and isophthaloyl chloride (IPCl)

Preparation and gas separation performance of thermally rearranged poly(benzoxazole-co-amide) (TR-PBOA) hollow fiber membranes deriving from polyamides

Structural evolution and gas separation properties of thermally rearranged polybenzoxazole (TR-PBO), polymer-carbon transition (PCT) and early-stage carbon (ESC) membranes derived from a 6FDA-hydroxyl-functionalized Tröger's base polyimide

Optimizing Porosity for Membrane-based Gas Separations

Selective in-situ water removal by polybenzoxazole hollow fiber membrane for enhanced CO 2 methanation

Simulation and Feasibility Study of Using Thermally Rearranged Polymeric Hollow Fiber Membranes for Various Industrial Gas Separation Applications