Abstract:Fouling is one of the most significant problems for internally enhanced tubes installed in the shell and tube condensers. Due to the lack of long-term test data, current fouling models are developed based on accelerated particulate fouling tests that have the low precision and hence are inapplicable for predicting combined fouling in most practical cooling tower systems. In addition, the constant values of fouling resistance (factor) recommended by the Air-Conditioning, Heating, and Refrigeration Institute (AHRI) are extremely limited under different operating conditions. To overcome these challenges, this research developed and validated two fouling prediction models based on experimental long-term tests. One of the models was in the form of a ratio of asymptotic fouling resistance of the enhanced tube to that of the plain tube (<math>Rf∗/Rf,p∗</math>), and the other one was in the form of the asymptotic fouling resistance of the directly enhanced tube (<math>Rf∗</math>). Both models considered water quality, water velocity, and the tube geometries as the variables with the acceptable accuracy for prediction. 1) For the water quality, the parameter of valid concentration (<math>Ccom</math>) of cooling water was defined in this study, which reflected the potential amount of valid components to form the fouling. 2) For the water velocity, its impacts on the two critical parameters of the fouling process: sticking probability (<math>P</math>) and deposit bond strength (<math>ξ</math>) were investigated using experimental studies. Test results showed that in enhanced tubes with the increased water velocity the sticking probability (<math>P</math>) decreased continuously while the deposit bond strength (ξ) initially increased, and then, decreased. 3) For the tube geometries, by taking the parameters of tube geometries as variables the multi-variable correlations of the sticking probability (<math>P</math>) and deposit bond strength (<math>ξ</math>) were developed. From the results the generalized fouling prediction model as a ratio of asymptotic fouling resistance (<math>Rf∗/Rf,p∗</math>) was recommended for the application in HVAC&R industry due to its suitability and accuracy in practical project applications.

A Novel Fouling Measurement System: Part I. Design Evaluation and Description

A Novel Fouling Measurement System: Part II. Commissioning

Experimental Study on Fouling in the Heat Exchangers of Surface Water Heat Pumps

Forecasting and Discussing of the Fouling Characteristic of the Plain Tube

Development of on-line monitoring apparatus of fouling thermal resistance and its caculation method of heat transfer

Experimental Study on the Interaction Between Particulate Fouling and Precipitation Fouling in the Fouling Process on Heat Transfer Tubes

Experimental study on the fouling and heat transfer characteristics of enhanced tubes used in a cooling tower water system with the actual water quality

Heat Transfer and Fouling Performance of Finned Tube Heat Exchangers: Experimentation Via on Line Monitoring

Uncertainty Analysis on an Online Measurement Method for Monitoring Fouling Resistance of Chiller

Decoupling Analysis on the Variations of Liquid Velocity and Heat Flux in the Test of Fouling Thermal Resistance

Dynamic simulation detection and reckoning of primary cooling water fouling characteristic parameters

Investigation on fouling of enhanced tubes used in a cooling tower water system based on a long-term test

A generalized prediction model of waterside fouling for internally enhanced tubes in shell and tube condensers

Investigation of a Falling Film Tube Bank Heat Exchanger with Baffle Design for Water Recovery Applications

Analysis of Fouling Characteristic in Enhanced Tubes Using Multiple Heat and Mass Transfer Analogies

Numerical Analysis Of Cooling Tower Water Fouling In Enhanced Tubes

A survey of cooling tower water quality for condenser tube fouling potential

Modeling Oscillatory Fouling in Enhanced Tubes in Cooling Tower Systems

Experimental Study of Fouling on Heat Transfer Surface During Forced Convective Heat Transfer

The Experimental Studying On Fouling Resistances Of Cooling Water In Condenser Of Chiller

Experimental/Numerical Investigation and Prediction of Fouling in Multiphase Flow Heat Exchangers: A Review