Abstract:The effect of hydrogen on the hot deformation behavior and microstructural evolution of Ti-44Al-6Nb-1Cr-2V (at.%) alloys were investigated at temperature range of 1373-1523 K under strain rate of 0.01 s(-1) . The true stress strain curves show that the peak stress decreases from 323 MPa to 97 MPa when deformation temperature increases from 1373 K to 1523 K. The peak stress is decreased by 30% after hydrogenation with 2% H, which corresponds to the decrease of deformation temperature by about 50 K, it denotes that hydrogen can promote a solution softening effect in TiAl alloys. This is attributed to hydrogen promoted the dynamic recrystallization, hydrogen-induced dislocation movement and hydrogen-stabilized the B2 phase. For dynamic recrystallization, the calculated results show that hydrogen accelerates the onset of dynamic recrystallization, which means that hydrogen promotes the dynamic recrystallization kinetics. For dislocation movement, EBSD results show that the fraction of low-density dislocation region increases from 59.6% to 79.7% after hydrogenation with 2% H, which indicates that hydrogen reduces the dislocation tangles and dislocation density. For B2 phase, more softening B2 phases are observed in hydrogenated alloy compared with that in unhydrogenated alloy, which results from hydrogen-promoted the transition of L (alpha(2)/gamma) gamma + B2. The positive effect of hydrogen on TiAl alloys provides an effective method to improve the hot workability of TiAl alloys. (C) 2016 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

Hydrogen Induced Softening and Hardening for Hot Workability of (tib + TiC)/Ti-6Al-4V Composites

High Temperature Deformation Behavior of Melt Hydrogenated (tib + Tic)/Ti-6al-4v Composites

Hydrogen Induced Microstructure Evolution of Titanium Matrix Composites

Hot-deformation Behaviour and Hot-Processing Map of Melt-Hydrogenated Ti6Al4V/(TiB+TiC)

Effects of Melt Hydrogenation on the Microstructure Evolution and Hot Deformation Behavior of TiBw/Ti-6Al-4V Composites

Improvement In Hot Workability Of Titanium Matrix Composite By Thermohydrogen Treatment

Microstructure Evolution and Enhanced Hot Workability of TiC/Ti-6Al-4V Composites Fabricated by Melt Hydrogenation

Hot deformation behavior and microstructure evaluation of hydrogenated Ti-6Al-4V matrix composite

Effect of Hydrogen on Microstructure and High Temperature Deformation of (tib + TiC)/Ti–6Al–4V Composite

Effect of Melt Hydrogenation on Microstructure Evolution and Tensile Properties of (tib + TiC)/Ti-6Al-4V Composites

Effect of hydrogen on deformation induced phase transformation and hot workability of Ti2AlN/Ti46Al4Nb1Mo composites

Hydrogen-induced hot workability in Ti-6A1-4V alloy

Effect of hydrogen on superplastic deformation of (TiB + TiC)/Ti-6Al-4V composite

Microstructural Characterization and Mechanical Properties of (tib + TiC) Reinforced Ti–6Al–4V Prepared by Melt Hydrogenation

Hydrogen-induced Softening of Ti–44Al–6Nb–1Cr–2V Alloy During Hot Deformation

Positive Effect of Hydrogen on Interface of in Situ Synthesized Ti-6Al-4V Matrix Composites

Hydrogen-induced microstructure optimization and mechanical properties enhancement of forged (TiB + TiC)/Ti6Al4V

Insights into hydrogen-induced strengthening mechanism of TiC/Ti6Al4V via experiments and first-principles calculations

Exploration and Development of (tib + TiC)/Ti6Al4V Through the Economically Viable Melt Hydrogenation Technique

The Effect of Hydrogen on the Strengthening and Softening of Ti–6Al–4V Alloy

Effect of Thermo Hydrogen Treatment on Microstructure and Mechanical Properties Of(tib,tic)/ti-6Al-4v Composite