Abstract:In a switchgear, an external transverse magnetic field (ETMF) is generated by the U type loop consisting of the vacuum interrupter, external busbar and conductive rod connected to the vacuum interrupter. The ETMF will make the vacuum arc deflected and strengthen the contraction of the arc. This can increase the probability of breaking failure. To weaken the adverse effect of the ETMF, the real magnetic field data of the arc area with different structure parameters when the length of conductive rod, external busbar and phase distance is changed are obtained by establishing simulation model in this paper. Taking the real magnetic field data as the boundary condition, this paper obtains the typical parameters of the vacuum arc plasma with different structure parameters by using the established three-dimensional high-current vacuum arc magnetohydrodynamics model. The simulation results show that the ETMF makes the transverse magnetic field (TMF) of the arc area asymmetric, which leads to an arc deflection. Reducing the length of the conductive rod connected to the vacuum interrupter to 50 mm can effectively improve the asymmetry of the TMF caused by the EMTF, weaken the arc deflection phenomenon, make the distribution of the plasma parameters more uniform, and increases the utilization of the anode contact surface. Moreover, it can not only reduce the heat flux density into the anode as a whole, but also reduce the heat flux density in the high heat flux density area, so as to effectively reduce the degree of anode activity and improve the negative effects caused by the anode activity. The changes of other external structural parameters have less influence on the improvement of the vacuum arc deflection phenomenon. Increasing the phase spacing to 275 mm or reducing the length of the external bus bar to 100 mm can only slightly weaken the arc deflection.

Effect of grounded shield on electric field distribution for solid insulation vacuum circuit breaker

Interdependence of Pressure and Shield Potential in Interrupter of Vacuum Circuit Breaker

Insulation Design And Analysis On High Voltage Vacuum Interrupter

Effect of Grounded Coating on Insulation Performance for Solid Insulation Ring Main Unit

Electric Field Analysis of Typical Surface Insulation Configurations in Vacuum

Analysis of Influence Factors on AC Breakdown Characteristics of Rod-Barrier Gap and Electric Field Simulation

Breakdown of shield gaps in vacuum interrupters

Study on the Distribution Characteristics of Actual Magnetic Field in Vacuum Interrupter

Prediction Method of Breakdown Voltage Probability Distribution Considering Area Effect for Shield Gaps in Vacuum Interrupter

Current distribution and power loss within the sliding contact structure of vacuum circuit breaker

Electric Field Optimization Method of Multi-Stage Floating Shield Vacuum Interrupter

Calculation ana Analysis of the Electric Field Distribution in High-voltage Interrupter and Its Advance Structure

Research on Insulating Structure for High Voltage Vacuum Interrupter

Study on High Voltage and Large Capacity Vacuum Interrupters

Investigation on Breakdown Characteristics in Contact Gap for Vacuum Interrupters Based on Area Effect

Optimal Design of Insulation of 3.6kV Vacuum Interrupter

Electric Field Distribution And Optimization Of Different Shielding Device For Composite Insulators In +/- 1100kv Indoor Dc Yard

Electric Insulation Characteristics of Long Contact Gap in High Voltage Vacuum Interrupter

Numerical Investigation on the Influence of Circuit Breaker Structure Parameters on Vacuum Arc Behaviors

Electric Field and Sheilding Effect Analysis of 1100kV DC SF6 Gas Insulated Wall Bushing

Analysis and Design in Extra High Voltage Circuit Breakers Employing Shunted Capacitors