Vacuum Brazing of the Gr/2024Al Composite and TC4 Alloy Using AgCuTi Filler Alloy with Ni-Al Interlayer As Auxiliary Heat Source

J. M. Shi,J. C. Feng,H. Liu,X. Y. Tian,L. X. Zhang

DOI: https://doi.org/10.1016/j.jallcom.2016.10.049

IF: 6.2

2016-01-01

Journal of Alloys and Compounds

Abstract:In vacuum, the Gr/2024Al composite and TC4 alloy were brazed using AgCuTi filler alloy with the assist of Ni-Al interlayer as auxiliary heat source. Because of the thermal explosion synthesis reaction of Ni-Al interlayer, lots of heat can be produced and released, which promises that AgCuTi filler alloy melts and the Gr/2024Al composite and TC4 alloy brazes at low temperature. This method avoids the volatilization of Al in the Gr/2024Al composite at high brazing temperature, keeping the property of the Gr/2024Al composite. According to SEM analysis result, the Gr/2024Al composite reacts with the AgCuTi filler alloy to form a Ti3AlC2 layer adjacent to the composite, which is the key factor to obtain a perfect joint. A series of Ni-Al compounds form after the thermal explosion synthesis reaction of the Ni-Al interlayer. The particle sizes of Ni and Al have important effects on the thermal explosion synthesis reaction, and then influence the interfacial reaction and the formation of the Ni-Al compounds. The maximum shear strength reaches 13 MPa when the diameter of the Ni and Al particles are 10 mu m and 7 mu m respectively. Cracks primarily happen in the Gr/2024Al composite and propagate in the composite away from the brazing seam. (C) 2016 Elsevier B.V. All rights reserved.