Abstract:<p>Hot ring rolling (HRR) is an advanced partial progressive forming technology that can directly manufacture various sizes of precision bearing rings. How to prefabricate the ring blank will affect the utilization rate of materials, flow lines distribution and microstructure in the forging of bearing rings. To improve product quality, a better understanding the evolution process of flow lines and microstructure during the forging process of bearing rings is needed. The purpose of this paper was to prefabricate the ring blank by back extrusion (BE) and use the HRR process (BE-HRR) to manufacture the pre-forged ring blank into 8Cr4Mo4V steel roller bearing inner ring. The development of flow lines, microstructure and mechanical properties during BE-HRR and spheroidizing annealing (SA) were systematically explored. By interrupting the separate BE-HRR processes were achieved resulting in analysis flow lines and characterization microstructure of each process. The macrostructure results show that the flow lines simulation results of each process are consistent with the experimental results. The reasonable flow lines distribution of roller bearing rings can be obtained by using this technology. The maximum deformation position of the BE and HRR process is in the inner diameter of ring. By combining optical microscopy (OM) and scanning electron microscopy (SEM) results were shown that the microstructure of the bearing ring is inhomogeneous in the whole BE-HRR process, but the microstructure of the bearing ring becomes uniform after SA. The primary carbides are distributed fibrously throughout the BE-HRR process and will not dissolve and disappear. The ultimate tensile strength (UTS) of HRR along the axial direction (AD) and circumferential direction (CD) is higher than that along the radial direction (RD), indicating distinct mechanical anisotropy due to different crack length and fracture paths along elongated grains. After SA, the elongation (EL) along the AD is significant higher than RD and CD owing to smaller grain sizes and microcracks tending to form and propagate first along the flow lines.</p>

Combined Warm Extrusion Process and Its Die of Bearing Inner and Outer Rings

Cold-extrusion Die Design of Subsidiary Transmission Shaft

Optimized Design for a Combined Die with Two Stress Rings in Cold Forging Considering Thermal-Mechanical Effects

Forming process chain for manufacturing complex conical-section profiled rings: On a co-design method

Study on Warm and Cold Extrusion of Cup-shaped Part

Analytical Solution of Thermo-Elastic-Plastic Deformation of the Combined Forging Die

Control of Flow Lines During the Forging Process of Bearing Outer Rings with a Deviated Groove

Numerical Simulation for Forging Process of Bearing Rings

Study on isothermal precision forging process of an aluminum alloy ring seat

SIMULATION ANALYSIS OF WHEEL BEARING FORGING PROCESS BASED ON DEFORM

A novel process for manufacturing large-diameter thin-walled metal ring: Double-roll pendulum hot rotary forging technology

Preform Design and Microstructure-Property Analysis for Isothermal Extrusion of Complex Box-Shaped Components

Casting Design Optimization Using Numerical Simulation of Precision Forging Die for Large Titanium Alloy Integral Bulkhead

Macrostructure, microstructure and mechanical properties evolution during 8Cr4Mo4V steel roller bearing inner ring forging process

Strength Design and Structural Optimization of Cold Extrusion Die for Cylindrical Workpieces

Analysis on the Process of Cold Enclosed Precision Forging of Starlike Sleeve

Numerical simulation and experimental study on cold extrusion process for clutch outer gear hub with inner tooth shapes

Study on the Material Characteristic and Process Parameters of the Open-Die Warm Extrusion Process of Spline Shaft with 42crmo Steel

STUDY ON THE NUMERICAL SIMULATION OF MULTI-STAGE ROTARY FORGING OF A NON-AXISYMMETRIC PART AND THE CAE ANALYSIS OF THE DIE STRENGTH

Improvement of Axial Forging Process for Spline Shaft by Die Design